Extension Cords; Specific Safety Rules For Jig Saws - Genesis GJS450 Manual Del Operario

EXTEnSiOn COrDS

grounded tools require a three wire extension cord
use either a two or three wire extension cord. As the distance from the power supply outlet increases,
you must use a heavier gauge extension cord. using extension cords with inadequately sized wire
causes a serious drop in voltage, resulting in loss of power and possible tool damage. Refer to the
table shown below to determine the required minimum wire size.
The smaller the gauge number of the wire, the greater the capacity of the cord. for example: a 14-
gauge cord can carry a higher current than a 16-gauge cord. When using more than one extension
cord to make up the total length, be sure each cord contains at least the minimum wire size required.
If you are using one extension cord for more than one tool, add the nameplate amperes and use the
sum to determine the required minimum wire size.
guidelines for Using Extension Cords
• If you are using an extension cord outdoors, be sure it is marked with the suffix "W-A" ("W" in
Canada) to indicate that it is acceptable for outdoor use.
• Be sure your extension cord is properly wired and in good electrical condition. Always replace a
damaged extension cord or have it repaired by a qualified person before using it.
• Protect your extension cords from sharp objects, excessive heat, and damp or wet areas.
Recommended Minimum Wire Gauge for Extension Cords (120 Volt)
Nameplate Extension Cord Length
Amperes
25 Feet
(At Full Load)
0–2.0
18
2.1–3.4 18
3.5–5.0 18
5.1–7.0 18
7.1–12.0
18
12.1–16.0
14
16.1–20.0 12

SPECiFiC SAFETY rULES FOr Jig SAWS

WArning:
(gAinED FrOM rEPEATED USE) rEPLACE STriCT ADHErEnCE TO
PrODUCT SAFETY rULES. if you use this tool unsafely or incorrectly, you can
suffer serious personal injury!
WArning:
an operation where cutting tools may contact hidden wiring or its own cord.
Contact with a "live" wire will make exposed metal parts of the tool "live" and
shock the operator!
• Avoid cutting nails,
• Do not cut hollow pipe.
• Check for the proper clearance
blade will not strike the floor, work bench, and etc
• Make sure the blade is NOT contacting the work piece
is turned on.
Variable Speed Jig Saw
Operator's Manual
50 Feet 75 Feet
18 18
18 18
18 16
16 14
14 12
12 10
10 8
DO nOT LET COMFOrT Or FAMiLiAriTY WiTH PrODUCT
Hold tool by insulated gripping surfaces when performing
inspect work piece for any nails and remove them before operation.
100 Feet 150 Feet
18
16
14
12
10
10
8
beyond the work piece before cutting so that the
.
GJS450
. Double insulated tools can
200 Feet
16 16
14 14
12 12
12 10
8 8
8 6
6 6
before the switch