Extension Cords - Genesis GJS500 Manual Del Operario

Turn power tool off, and disconnect the plug
•
from the power tool before making any adjustments, changing the accessories, or storing the tools. Such
preventive safety measures reduce the risk of an accidental start up which may cause personal injury.
Store idle tool out of reach of children and other inexperienced persons
•
dangerous in the hand of untrained users.
Maintain power tools with care
•
component breaks, and any other conditions that may affect the tool's operation. A guard or any other part that
is damaged must be properly repaired or replaced by an authorized service center to avoid risk of personal
injury.
Use recommended accessories
•
manufacturer or intended for use on this type tool may cause damage to the tool or result in personal injury to
the user. Consult the operator's manual for recommended accessories.
Keep cutting tools sharp and clean
•
are less likely to bind and are easier to control.
Feed the workpiece in the correct direction and speed.
•
blade, cutter, or abrasive surface against the direction of the cutting tool's direction of rotation only. Incorrectly
feeding the workpiece in the same direction may cause the workpiece to be thrown out at high speed.
Never leave the tool running unattended, turn the power off
•
until it comes to a complete stop.
•
Never start the power tool when any rotating component is in contact with
the workpiece.
WArNING:
OTHEr AIrBOrNE PArTICLES, INCLUDING WOOD DUST, CrYSTALLINE SILICA DUST
AND ASBESTOS. Direct particles away from face and body. Always operate tool in a
well-ventilated area and provide for proper dust removal. Use dust collection system
wherever possible. Exposure to the dust may cause serious and permanent respiratory
or other injury, including silicosis (a serious lung disease), cancer, and death. Avoid
breathing the dust, and avoid prolonged contact with the dust. Allowing dust to get into
your mouth or eyes, or lay on your skin may promote absorption of harmful material.
Always use properly fitting NIOSH/OSHA approved respiratory protection appropriate
for dust exposure, and wash exposed areas with soap and water.
SERVICE
• Have your power tool serviced by a qualified repair person using only
identical replacement parts
Service your power tool periodically
•
portion of the tool since internal wires may be misplaced or pinched.

EXTENSION COrDS

Grounded tools require a three wire extension cord
use either a two or three wire extension cord. As the distance from the power supply outlet increases, you must
use a heavier gauge extension cord. using extension cords with inadequately sized wire causes a serious drop
in voltage, resulting in loss of power and possible tool damage. Refer to the table shown below to determine the
required minimum wire size.
The smaller the gauge number of the wire, the greater the capacity of the cord. for example: a 14-gauge cord
can carry a higher current than a 16-gauge cord. When using more than one extension cord to make up the total
length, be sure each cord contains at least the minimum wire size required. If you are using one extension cord
for more than one tool, add the nameplate amperes and use the sum to determine the required minimum wire
size.
Variable-Speed Orbital-Action Jig Saw
Operator's Manual
. Check for proper alignment and binding of moving parts,
. using accessories and attachments not recommended by the
USE OF THIS TOOL CAN GENErATE AND DISBUrSE DUST Or
. This will ensure that the safety of the power tool is maintained.
SAVE THESE INSTRUCTIONS
from the power source and/or battery pack
. Properly maintained cutting tools with sharp cutting edges
. When cleaning a tool, be careful not to disassemble any
GJS500
. It is
feed the workpiece into a
. Do not leave the tool
.
Double insulated tools can