Switching On/Off - Dexter 20VRH2-17.1 Manual De Instrucciones

FR FR
ES ES 5. OPERATION
PT PT 2. To remove the battery pack, press the release button on the battery pack and pull out the battery
pack.
Notes: This is information for your reference. For details, pls. read the instruction of the battery
IT IT
pack.
EL EL

SWITCHING ON/OFF

1. To start the machine, press the On/off switch and keep it pressed.
PL PL
The power light lights up when the On/off switch is slightly or completely pressed, and allows the
work area to be illuminated when lighting conditions are insufficient.
RU RU
2. To switch off the machine, release the On/off switch.
For low temperatures, the power tool reaches the full hammer / impact capacity only after a certain
KZ UA
time. To save energy, only switch the power tool on when using it.
Note: For safety reasons, the On/off switch cannot be locked; it must remain pressed during the
entire operation.
UA KZ
SETTING THE SPEED / IMPACT RATE
RO RO
The speed/impact rate of the switched on power tool can be variably adjusted, depending on how
far the On/off switch is pressed.
BR
BR
Light pressure on the On/off switch results in low speed/impact rate. Further pressure on the switch
increases the speed/impact rate.
EN
EN
DRILLING
Drilling into wood, wood similar materials, plastic or metal could be applied by means of a suitable
keyless / keyed drill chuck with SDS-PLUS adapter (not provided).
1. Apply proper feeding force and rotation speed depending on drill bit characteristics and
material to be drilled. Too big feeding force will overload the power tool, damage the drill bit
due to overheating, decrease drilling effectiveness and increase the risk of loss of control. Ask a
drill bit specialist for advice if necessary.
2. Check the bit and auxiliary handle status regularly before and during work, refit or replace it if
necessary.
3. Turn the mode selector to set the machine to the operation mode "Drilling without impact" and
insert the keyless / keyed drill chuck with SDS-PLUS adapter into the SDS-PLUS chuck.
4. Attach a suitable drill bit to the keyless / keyed drill chuck.
5. Punch the drilling point before operation in order to avoid slipping of the drill bit.
6. Always hold the product perpendicular to the point to be drilled. Holding it at an angle may
cause slipping or jamming of the drill bit.
7. Always place the drill tip directly on the point to be drilled first and then switch the product on.
328