baltur BT 40 DSN 4T Instrucciones página 35

1 - MAIN TANK
2 - FILTER
3 - CIRCULATION PUMP
4 - WATER AND SYSTEM DISCHARGE
5 - NORMALLY CLOSED AIR-GAS DISCHARGE
6 - FUEL RECOVERY TANK AND DEGASSING UNIT
7 - NON-RETURN VALVE
6 - BY PASS (NORMALLY CLOSED)
9 - ADJUSTABLE PRESSURE REGULATOR, 0.5 - 2 BAR
10 - PRESSURE GAUGE (0-4 BAR)
11 - HEAVY OIL HEATING COIL, STEAM OR HOT WATER
BASIC HYDRAULIC DIAGRAM FOR MULTIPLE TWO-FLAME OR
MODULATING BURNERS FUNCTIONING WITH DENSE FUEL OIL
(MAX 50 °E AT 50 °C) AND AUXILIARY HEATER
1 - MAIN TANK
2 - FILTER
3 - CIRCULATION PUMP
4 - WATER AND SYSTEM DISCHARGE
5 - NORMALLY CLOSED AIR-GAS DISCHARGE
6 - FUEL RECOVERY TANK AND DEGASSING UNIT
7 - NON-RETURN VALVE
6 - BY PASS (NORMALLY CLOSED)
9 - ADJUSTABLE PRESSURE REGULATOR, 0.5 - 2 BAR
10 - PRESSURE GAUGE (0-4 BAR)
11 - THERMOMETER
BASIC HYDRAULIC DIAGRAM FOR MULTIPLE
TWO-FLAME OR MODULATING BURNERS USING
FUEL OIL (MAX 15 °E AT 50 °C)
HEATING ELECTRICAL LEAD (IF NECESSARY)
N.B. The thank for recovery of hot oil
(diameter 150 mm, height 400 mm) should
be installed as near as possible to the
burner and about 0.5 m, above the pump.
12 - ELEMENT
13 - AUXILIARY HEATER
14 - STEAM COIL OR HOT WATER TO HEAT THE OIL
15 - HEAVY OIL HEATING COIL, STEAM OR HOT WATER
16 - HUB DIAMETER 100MM, HEIGHT 300MM
HEATING ELECTRICAL LEAD (IF NECESSARY)
N.B. The thank for recovery of hot oil (diameter 150 mm,
height 400 mm) should be installed as near as possible
to the burner and about 0.5 m, above the pump.
35
N° BT 8511/6
N° BT 8513/7