Installation; Diagram Of Connections - Nice OTA 30 Manual De Instrucciones

• Remember that the unit is live (electrocution hazard, risk of fire ...) and contains electronic components that, due to their
nature, are particularly fragile.
•
Make sure you have all the necessary materials available and that they are suitable for this use.

2.1) INSTALLATION:

Before actually starting, carefully analyse all the risks relating to the automation you are about to install. Verify the sturdiness and
mechanical consistency of the gate, observe the safety margins and minimum distances. Evaluate with particular care the safety
devices to be installed and where to install them, always install an emergency stop device, in other words, a category 0 stop
device (compulsory interruption of power to the actuators).
Once you have carefully analysed the risks involved, you can install the unit, the actuators, the control (key selector or push
button panel) and safety (emergency stop, photoelectric cells, sensitive edges and flashing light) devices for the automation.
When installing the actuators, scrupulously follow all the instructions given in the instruction manuals which must be enclosed
with the motors. If some points are not very clear, do not install the unit without first having cleared up all doubts by consulting
our TECHNICAL OFFICE.
2.2) CONNECTIONS DIAGRAM:
Only when the gearmotor and relative control and safety elements have been installed can you do the wiring, following the
instructions given below.
While you are connecting the unit it must not, under any circumstances, be electrically powered.
As mentioned previously, some connections are different for the OTA 30 and ROA 30 versions
Switch 1 ON = Automatic movement
Switch 2 ON = Condominium functioning mode
Switch 3 ON = Remote reversal with photocell command
Switch 4 ON = Courtesy light on flashing light output
Fig. 2
PROGRAMMABLE
FUNCTIONS
1 2 3 4
FUSE 500mA
SECONDARY
TRANSFORM
MIN
MAX
FUSE
To safeguard the operator and avoid damaging components while you are wiring:
+ +
T. L. T. P.
STEP-BY-STEP
PHOTOCELL
STOP
STOKE
END
CH-AP
MOTOR
CAP
5A
AP-CH
the unit must, under no circumstances, be electrically powered.
Read all the instructions through at least once!
OTTO
44
ANTENNA
43
42
2° RADIO CH
41
14
STEP-BY-STEP
13
12
PHOTOCELL
11
10
STOP
9
8 FCC
(OPTIONAL)
FCA
7
+
6 24 Vcc
Max 100 mA
–
5
4
LUCY 230 Vac
MAX 100 W
3
"L" 230 Vac
2
"N' 50 Hz
1
English
ROBO
44
ANTENNA
43
42
2° RADIO CH
41
14
STEP-BY-STEP
13
12
PHOTOCELL
11
10
STOP
9
GATE OPEN INDICATOR
8
24 V Max 3 W
7
6 24 Vac
Max 100 mA
5
4
LUCY 230 Vac
MAX 100 W
3
"L" 230 Vac
2
"N' 50 Hz
1
13