Self-Learning Radio; Connecting An Alternative Radio Receiver; Maintenance - Nice SPIDER 6060 Manual De Instrucciones

English

4) SELF-LEARNING RADIO:

The unit includes a 433.92 Mhz radio receiver suitable for Flo1, Flo2, Flo4 and Very VE transmitters
Since the radio has a built-in self-learning system it is very simple to memorise the transmitter code.
To memorise the code proceed as follows:
1) If you are using a Flo transmitter select the code by means of the 10 mi -
croswitches.
For other types of remote controls you will have to select the code
according to the specific instructions.
2) Press and hold down the programming button on the unit (Fig. 6).
3) Press the button wanted on the transmitter (Fig. 7).
4) Wait until the courtesy light on the gearmotor turns on (about 2 seconds).
5) Let go of both buttons.
The code is now stored and you can verify it straight away.
The unit recognises only one code. If you memorise another code the first one
will be cancelled. Hence, if several transmitters are used select the same code
via the microswitches.
4.1 ADDING AN ALTERNATIVE RADIO:
There is a supplementary connector on the card for plugging in Nice RADIO receivers as an alternative to the radio already included
on the card. We recommend waiting until installation is complete before plugging in any alternative RADIO card and only after having
verified that the system works.
To plug in the alternative radio follow these instructions carefully:
1) Cut power off to the gearmotor by pulling the plug out.
2) Unhook the transparent cover on the external casing.
3) Remove the plastic guard on top of the adjustment trimmers.
4) Pull the external aerial's connection terminal out (Fig. 8) and connect the
aerial cable to it, paying attention to polarity.
5) Use a pair of cutters to cut the jumper underneath the aerial's connector
as shown in (Fig.8).
6) Plug the alternative radio in the connector.
7) Put the aerial terminal back in its connector as shown in Fig. 8.
8) Programme the radio as described in the alternative radio receiver
instructions.

5) MAINTENANCE:

No particular maintenance is required for the electronic card. However, check at least twice a year the proper working order and
adjustment of the device that controls maximum motor thrust and, if necessary, adjust with the trimmers ( see chap.3.1 ).
Check that the safety devices are working effectively (photoelectric cells, pneumatic edges, etc.) and check operation of the flashing
light.
6) INFORMATION ON MEASURES TO PROTECT THE ENVIRONMENT:
This product is made with different types of recyclable materials.
Inquire about recycling or dispoasl methods of the product,complying with the current local laws.
16
Fig.8
: Invisible part, covered by the casing
Fig.7
R A D I O