Inserting Paper - Mettler Toledo P25 Manual De Referencia

Note
RS232 interface only: the pilot lamp will flash until an instrument is connected. If the lamp is still flashing
check the chapter [Troubleshooting } Page 16].

4.3 Inserting paper

1 Remove paper cover (pull on the back) (1).
2 Insert the paper rotary axis through the core of the
paper roll (2).
3 Feed paper through the slot in the printing unit in the
direction of the arrow (3).
4 Press and hold until enough paper has been fed (4).
5 Lead paper through the paper cover slot.
6 Place the paper cover (1) on.
If, after the first printouts the connection settings
(Bauderate, Bit, Handshake) of the balance change, the
printer must be restarted. Switch off / on to start the auto
bauderate detection again. Auto bauderate can be
switched off.
8 Installation and Putting into Operation​ ​
3
4
2
1
Printer