Installation Instructions - Classic Flame 23EF024GRA Manual De Instrucciones

Position your completed Wood Mantel close to its
final location. Make sure you can access the back
of the Fireplace, as your Electric Fireplace Insert will
be installed from the back.
Using a Phillips head screwdriver, remove the
screws and the metal mounting brackets attached
on either side of the fireplaces center opening. Next
unpack the Electric Fireplace Insert carefully. Position
insert behind fireplace with front facing the wood
mantel. With the help of an adult assistant, lift the
Insert and gently slide it into the opening in the
mantel until the flange is flush against the inside of
the fireplace. Make sure insert is centered left and
right in the opening. Be careful when placing insert
and adjusting, bottom ofi nsert could scratch the finish
of the wood base/hearth of your fireplace. Re-attach
the mounting brackets
with the Phillips head screwdriver, and supplied
screws. DO NOT OVER TIGHTEN.
Emberbed
Heater/Blower Assembly
Door Handles (2)
Glass Doors (2)
Logs
Logs Brackets
Control Panel PCB
Control Panel Front Graphic - Plastic
Mesh Curtain (2)
Curtain Rod (2)
Front Projection Screen
Flame Generator Drive Motor
Flame Generator/Spinner
Decorative Brick Panels
Remote Control
Main PCBA

INSTALLATION INSTRUCTIONS

PARTS LIST
P a t r N a m e
With the help of an assistant, carefully lift completed
unit and place it with the front facing out in the final
location you have chosen for your fireplace. Make
sure to secure the electrical cord before lifting or
moving completed fireplace. When choosing a final
location, make sure you will have clear access to a
grounded electrical outlet.
INSERT MOUNTING
BRACKET
ELECTRIC
FIREPLACE
INSERT
23EF024GRA 28EF024GRS 33EF024GRS
E-3
Figure 2
REAR VIEW OF FIREPLACE