Classic Flame 23EF024GRA Manual De Instrucciones página 9

THE REMOTE CONTROL FEATURES WORK SEAMLESSLY WITH THE CONTROL PANEL FEATURES.
THE REMOTE TRANSMITTER MUST BE AIMED AT THE UPPER RIGHT CORNER OF THE FIREPLACE.
IF THE REMOTE TRANSMITTER IS NOT WORKING, PLEASE REPLACE THE BATTERIES WITH NEW ONE.
Please notes the remote receiver is located on the upper
right corner of the unit (picture 8). Must be aimed at the
upper right corner of the fireplace for your remote control
operation.
- STANDBY
The Power button will put the insert in a standby
mode. This will turn off all functions at once but
will hold the settings in memory. By pressing the
button again the unit will turn on at the same settings.
HEAT
On/off button toggles the heat between the highest
setting and off.
FLAME
The 2 FLAME button controls the flame effect. Press
the " " button to increase the brightness of the flames.
Each time the " " button is pressed it will decrease the
intensity of the flames. There are 6 brightness
levels including the "OFF" position. Will turn off the
volume and sparks at the same time when FLAME is on
off position.
VOLUME
Up and down controls for the six volume levels
including the off position.
EMBERS
This button will toggle rolling emberbed on/off.
CRACKLE
This button is for crack sound controls and sounds
can cycle among three settings: crackle and wind
effets, crackle only, and sound off.
SPARKS
This button will toggle the sparks on/off. The crackle
button must be switched on in order for SPARKS
function.
DOWNLIGHT
This button is only for 28EF024GRS and 33EF024GRS
inserts.There are three setting you can cycle through
including off, downlights on and shadow effect.
REMOTE CONTROL FUNCTIONS
E-8
Figure 8
Remote Receiver Inside
Figure 9
HEAT
VOL
CRACKLE
SPARK
NOTE: PLEASE OPERATE REMOTE TRANSMITTER AT A SLOW
MEASURED PACE. DEPRESS THE REMOTE CONTROL BUTTONS
WITH AN EVEN MOTION AND GENTLE PRESSURE. REPEATEDLY
PRESSING BUTTONS IN RAPID SUCCESSION MAY CAUSE THE
TRANSMITTER TO MALFUNCTION.
FLAME
EMBER
DOWN
LIGHT