Correct posture
• Rest for approx. 5 minutes before each measurement.
Otherwise there may be divergences.
• You can perform the measurement
while sitting or lying. To carry out a
blood pressure measurement, make
sure you are sitting comfortably with
your arms and back leaning on some-
thing. Do not cross your legs. Place
your feet flat on the ground. Make sure to rest your arm
and move it. Always make sure that the cuff is at heart
level. Otherwise significant deviations can occur. Relax
your arm and the palm of your hand.
• In order not to distort the result, it is important to keep still
during the measurement and not talk.
Measuring blood pressure
• Move the touch screen activation switch to the ON posi-
tion.
• Switch on the blood pressure monitor with the START/
STOP button
. After the full-screen display, the most
recently used user memory appears (
the user memory, press the MEM button and confirm
your selection with the START/STOP button
ton is pressed, the most recently used user memory is
automatically used after 5 seconds.
• Before the measurement, the last saved test result is
• The cuff automatically inflates. Cuff air pressure is
• • • • • • • • • • • • •
• After the pressure has been completely reduced, the sys-
• You can cancel the measurement at any time by press-
•
• The test result is saved automatically.
• To switch off the device, press the START/STOP button
or
). To change
. If no but-
Wait at least 5 minutes before taking another measurement!
20
briefly displayed. If there is no measurement in the mem-
ory, the instrument always displays the value .
released slowly. If a tendency towards high blood pres-
sure is already detectable, the cuff is pumped up again
and cuff pressure increased further. As soon as a heart
rate is detected, the heart rate symbol
tolic pressure, diastolic pressure and pulse readings are
displayed.
ing the START/STOP button
screen activation button to OFF.
appears if it has not been possible to perform the
measurement properly. Observe the section in these
instructions for use on error messages/troubleshooting
and repeat the measurement.
or push the touch screen activation switch to OFF. If
you forget to switch off the device, it switches off auto-
matically after approx. 1 minute.
is displayed.
or by pushing the touch