Maintenance And Storage - FLORABEST FRM 1200 D3 Manual De Instrucciones

G B I E
• Do not overload the equipment.
Work only within the speci-
fied power range and do not
change the regulator settings on
the motor. Do not use low-pow-
ered machines for heavy work.
Do not use your equipment for
purposes other than those for
which it is designed.
• Do not use the equipment near
inflammable liquids or gases.
Non-observance will result in a
risk of fire or explosion.
• Do not lift or carry the equip-
ment when the motor is running.
• Switch off the equipment and
disconnect the plug:
- Whenever you leave the ma-
chine,
- Before cleaning the
tion hole or removing block-
ages,
- When the equipment is out of
use,
- Before checking, cleaning or
working on the equipment,
- If the power cable is dam-
aged or frayed,
- If the equipment has hit a
foreign object or if strange
vibrations occur during work.
In this case, check the equip-
ment for damage and have it
repaired if applicable.
• Do not place feet or hands near
or under rotating parts. Do not
stand in front of the grass ejec-
tion hole during sickle mowing.
• Avoid wearing loose clothing or
clothing with hanging cords or
belts.
• Do not run the engine if you are
facing the chute.
2 4

Maintenance and Storage:

• Ensure that all nuts, bolts and
screws are tightened firmly and
the equipment is in safe work-
ing condition.
• Do not attempt to repair the
equipment yourself unless you
have been trained to do so.
Any work not specified in these
instructions is to be carried out
only by customer service centres
that we have authorised.
• Keep the equipment in a dry
location and out of reach of
children.
• Handle the equipment with
care. Keep tools sharp and
clean, in order to facilitate bet-
ter and safer work. Follow the
ejec- maintenance instructions.
• Wear protective gloves when
changing the cutting device.
• Regularly check the grass col-
lection device for wear and
strains. For safety reasons, re-
place worn or damaged parts.
When adjusting the blades,
take particular care to avoid fin-
gers being trapped between the
rotating blades and fixed parts
of the machine.
• Check that only replacement
tools authorised by the manu-
facturer are used.
• When servicing the cutting bla-
de on it that even if the voltage
source is switched off, the cut-
ting blade can be moved.
• Worn or damaged information
signs must be replaced.
• Allow the motor to cool before
storing the equipment in a con-
fined space.