Hilti TE 2 Manual De Instrucciones página 17

– To avoid the risk of injury, use only the genuine Hilti
accessories and additional equipment specified for
use with this tool.
– Observe the information printed in the operating
instructions concerning operation, care and main-
tenance. The tool and its ancillary equipment may
present hazards when used incorrectly by untrained
personnel or when used not as directed.
en
– The tool is intended for professional use.The tool
may be operated, serviced and repaired only by
authorized, trained personnel. This personnel must
be informed of any special hazards that may be
encountered.
The tool is designed for the following uses:
Use
TE 2 / TE 2-E / TE 2-S / TE 2-M:
Hammer drilling in concrete,
masonry and natural stone
TE 2-S:
Drilling with precision
hammering action in perforated – TE-C hammer drill bits
brick, tiles and marble
TE 2 / TE 2-E / TE 2-S:
Drilling in wood, drywall panels Quick-release chuck
and metal
TE 2-M:
Drilling in wood, drywall panels, Interchangeable quick-release chuck
tiles and metal
12
Main features of the tool
Class II electrical protection (double insulated) Z
Mechanical torque-limiting clutch
Grip and side handle with vibration absorption
TE-C chuck
TE-C insert tool system
Variable speed switch
Rotary-only drilling mode
Gearing and hammering mechanism with permanent
grease lubrication
Pivotable side handle (360°)
Mechanical depth gauge
Interface for quick-release chuck (TE 2-M)
Precision hammering action (TE 2-S)
High spindle speed without hammering action (TE 2-M)
Lockbutton for sustained operation
Right of technical changes reserved
Required insert tools
Drill bits with TE-C connection end Drilling in concrete:
– Short hammer drill bits
– Long hammer drill bits
Drill bits with TE-C connection end Drilling in brittle materials:
– Thin-barrel core bits
with TE-C adaptor
for insert tools
with cylindrical shank or hexagonal shank
for rotary-only drilling
Wood drill bits
Metal drill bits
Hole saws
for insert tools
with cylindrical shank or hexagonal
shank for rotary-only drilling:
Wood drill bits
Metal/stepped drill bits
Hole saws
Diameter range
Anchor holes of 4–22 mm dia.
Through holes of 4–22 mm dia.
Anchor holes of 4–22 mm dia.
Cutting sockets of 25–68 mm dia.
4–20 mm dia.
3–13 mm dia.
25–68 mm dia.
4–10 mm dia. in 2nd gear
10–20 mm dia. in 1st gear
3– 8 mm dia. in 2nd gear
8–13 mm dia. in 1st gear
25–68 mm dia. in 1nd gear