Troubleshooting; Declaration Of Conformity - Hilti TE 2 Manual De Instrucciones

Troubleshooting

Symptom
The tool doesn't start
No hammering action
Tool doesn't produce full
power
Drill bit cannot be released
EC declaration of conformity
Description:
Designation:
Year of design:
We declare, under our sole responsibility, that this product
complies with the following directives and standards:
2004/108/EC, 2006/42/EC, EN 55014-1, EN 55014-2, EN
60745-1, EN 60745-2-6, EN 61000-3-2, EN 61000-3-3
Possible cause
Fault in the electric power supply
Defective supply cord or plug
Switch defective
The tool is too cold
Function selection switch
set to rotary drilling
Cross-section of the
extension cord is inadequate
Control switch is not pressed fully
Function selection switch set
to precision hammering action
Forwards / reverse switch set
to reserve when drilling
Chuck not opened fully
Rotary Hammer
TE2 / TE 2-E / TE2-S / TE2-M
2005
Possible solution
Plug in another electric tool and check
whether it starts
Have it checked by an electrical
specialist and replace if necessary
Have it checked by an electrical
specialist and replace if necessary
Allow tool to reach the minimum
operating temperature
See section "Before use"
Set function selection switch to
hammer drilling
Use an extension cord of adequate cross-
sectional area. See section "Before use"
Press the control switch as far as it will go
Set function selection switch
to hammer drilling
Set forwards / reverse switch
to forwards
Pull the chuck locking sleeve back as
far as it will go and remove the insert
tool
Hilti Corporation
Paolo Luccini
Head of BA
Quality and Process Management
Business Area
Electric Tools & Accessories
01/2011
en
Jan Doongaji
Senior Vice President
BU Drilling & Demolition
01/2011
19