Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 36
Start-up
— Before you test a battery in a vehicle, turn off the
ignition, all accessories and loads. Close all the
vehicle doors and the trunk lid.
— 4 pieces of 1.5 V alkaline batteries (item no.
082702) must be in the battery compartment of
the testing device (on the rear). If these batter-
ies runs out of power, screen will show "replace
internal battery" or "power low". Replace these
4 alkaline batteries before starting the test. Con-
sider that the display shows no message until the
battery test is not correctly connected to the bat-
tery of the vehicle.
— Make sure the battery terminals are clean. Wire
brush them if necessary. Clamp the black load
lead to the vehicle negative battery terminal.
Clamp the red load lead to the vehicle positive
battery terminal.
When putting the devie into operation, adjust the language, time, date and brightness settings first. After
actuating the arror buttons you can select the corresponding settings.
BATTERY TEST◄ ► ↵
××.×× V
SYSTEM TEST◄ ► ↵
××.×× V
LANGUAGE ◄ ► ↵
SELECT
LANGUAGE ◄ ► ↵
ENGLISH

Menu setting

Press ◄ / ► to select language or system test.
Press Enter to test the battery
Press ◄ / ► to select language or battery test.
Press Enter to test the system
Press Enter to select the language
Press ◄ / ► to select battery test or system test.
Press Enter to select the language
(English, French, German, Spanish, Italian, Portugese, Japanese.)
Press Enter to confirm & to return to battery test
— Paper load: Open the printer cover. Insert paper
so that the printer is fed automatically with paper.
(This is only necessary in case of paper change
or if the device is put into operation.)
Inserting the paper roll (fig. I)
1. Connect the terminals to the checked battery.
2. Open the clear cover (printer cover) and raise
the green lever (right).
3. Insert the paper and close the printer cover.
Replacing the paper roll (fig. II)
1. Open the printer cover.
2. Raise the (green) rail ion the left to lift the printer
head and roll and to pull the paper out of the
compartment or to insert the paper in the com-
partment.
3. Draw slowly the paper directly from the paper
roll out of the compartment.
13

Publicidad

Tabla de contenido
loading

Tabla de contenido