•
Additionally, treat the device as faulty if any of the forth
mentioned applies: absence or illegibility of markings; absence
of any elements affecting the equipment form and function;
evidence of defects in or damage to hardware elements
including but not limited to cracks, sharp edges, deformation,
absence of parts, corrosion, and other forms of alteration; any
other condition that calls to question the suitability of the
equipment for its intended purpose.
•
Regular periodical inspections must be carried out by a
competent person at least once a year. For this purpose an
inspection record should be established (see the ending
sections of these instructions).
•
Before each use, it is obligatory to check the device and verify
that all its components (side plates integrity and smooth
rotation, sheave integrity and smooth rotation, clipping holes,
etc.) are faultless and in good working condition.
Packing, storage, maintenance and cleaning
Each product is packed with its INSTRUCTIONS FOR USE. Proper
maintenance and storage are imperative to ensure correct
functioning of the product (as well as all your equipment) and thus
your safety. Clean the product with a brush under running tap
water. If the stains persist, clean it in warm water (maximum 30 °C)
with ordinary soap. Then rinse thoroughly, wipe it with a towel and
dry naturally in a shaded ventilated place away from sources of
heat. If needed, lube sparingly the moving parts of a clean device
with silicon based oil.
Temperatures
While it is allowed to use this product within the temperature range
from -40 °C to 80 °C, it is advisable to stock it in a dry place at room
temperature.
Lifetime
Lifetime is set by the date of production and is theoretically
unlimited. Service time starts with the date of first use and depends
on frequency and mode of application, on environment where it is
used (e.g. marine, cave, corrosive atmosphere), and on mechanical
wear and damage. It is therefore very difficult to determine the
expected service time of a particular device. Its due retirement is
therefore left to user's regular examinations and competent
person's annual inspections.
Guarantee and its limitations
This product is guaranteed for 3 years from purchase against any
faults in materials or manufacture. The guarantee does not apply in
cases of misuse, normal wear and tear, unauthorised modifications
or alterations, improper use, improper maintenance, accidents,
negligence, damage or if the product is used for a purpose it was
not designed for. If you discover a defect, you should return the
product to the reseller you purchased the product from or directly
to.
16 16