Troubleshooting Guide - Bostitch BTFP02028 Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

FIG. 4

GlOSSARY

Cubic feet per minute.

CFm:

Standard cubic feet per minute; a unit of measure of air delivery.

SCFm:

Pounds per square inch; a unit of measure of pressure.

PSI:

Metric pressure measurement. 1 kilopascal equal 1000 pascals.

kPa (kIlOPaSCal):

COde CerTIFICaTION:

ETL®, CETL, CETLUS, have been evaluated by OSHA certified independent safety laboratories

and meet the applicable Standards for Safety.

*UL® is a registered trademark of Underwriters Laboratories and ETL® is a registered

trademark of Electrical Testing Laboratories.

While the motor is off, air tank pressure drops when accessory is used.

CuT-IN PreSSure:

When the tank pressure drops to a certain low level the motor will restart automatically. The

low pressure at which the motor automatically restarts is called cut-in pressure.

When an air compressor is turned on and begins to run, air pressure in

CuT-OuT PreSSure:

the air tank begins to build. It builds to a certain high pressure before the motor automatically

shuts off, protecting your air tank from pressure higher than its capacity. The high pressure at

which the motor shuts off is called cut-out pressure.

The circuit carrying electricity from electrical panel to outlet.

BraNCH CIrCuIT:

For proper operation of your air compressor, it is recommended that a 50% duty

duTy CyCle:

cycle be maintained; that is, the air compressor should not run more that 5 minutes in any 10

minute period.

TROUBlESHOOTING GUIDE

This section provides a list of the more frequently encountered malfunctions, their causes

and corrective actions. The operator or maintenance personnel can perform some corrective

actions, and others may require the assistance of a qualified BOSTITCH technician or your

dealer

Problem

Excessive air tank pressure-safety valve pops off ............................................................................1, 2

Air leaks ............................................................................................................................................................3

Air leaks in air tank or at air tank welds ..................................................................................................4

Air leaks between head and valve plate .................................................................................................5

Air leaks from safety valve...........................................................................................................................6

Knocking Noise .............................................................................................................................................6

Pressure reading on the regulated pressure gauge drops when an accessory is used............7

Compressor is not supplying enough air to operate accessories.......................8, 9, 10, 11, 12, 22

Regulator knob has continuous air leak.................................................................................................13

Regulator will not shut off air outlet........................................................................................................13

Motor will not run...............................................................................................6, 14, 15, 16, 17, 18, 19, 20

Squealing Sound...........................................................................................................................................21

Products that bear one or more of the following marks: UL®, CUL, CULUS,

WARNING

DO N OT ADJUST FACTORY SETTINGS.

TO REDUCE RISK OF ELE CTRIC SHOCK

ADVERTENCIA

DO N OT REMOVE COVER.

Pressure controls set at factory for

maximum sa fe ope ration.

AVERTISSEMENT

ADVERTENCIA

NO HAGA CAMBIOS EN LOS AJUSTES

DE FÁBRICA. NO RETIRE LA TAPA PARA