Descargar Imprimir esta página

Tools Required For Assembly - SpeedEPart Agri-Fab 45-03371 Manual Del Usuario

Publicidad

For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
CONTENTS
SAFETY ........................................................................... 4
ASSEMBLY ...................................................................... 5
OPERATION .................................................................. 11
MAINTENANCE ............................................................ 11
STORAGE ..................................................................... 12
SERVICE AND ADJUSTMENTS ................................... 12
TROUBLESHOOTING ................................................... 12
REPAIR PARTS ............................................................. 22
ASSEmBLY

TOOLS REqUIRED FOR ASSEmBLY

(1)
Knife or Scissors
(2)
1/2" Open End or Box End Wrenches
All loose parts are shown on page 2. Fasteners in the parts
bag are shown full size on page 3.
Remove the hardware pack and all loose parts from the
carton and verify that all the parts and fasteners shown on
pages 2 and 3 are included.
ASSEmBLY OF SWEEPER
Note: Right hand (R.H.) and left hand (L.H.) are determined
from the operator's position while seated on the tractor.
1. (Figure 1) Assemble the angle bracket to the sweeper
housing using a 5/16" x 3/4" hex bolt (F) and a 5/16"
nylock nut (G). Make sure the bracket is turned as
shown and aligned straight with the housing and then
tighten.
5/16" NYLOCK NUT (G)
ANGLE
BRACKET
5/16" x 3/4"
HEX BOLT (F)
ENGLISH
2. Cut off the plastic tie that holds the height adjustment
3. (Figure 2) Assemble the R.H. hitch tube to the sweeper
4. (Figure 3) Fasten the hitch tubes together using two
1
5
www.mymowerparts.com
tube in place.
housing using two 5/16" x 1-1/2" carriage bolts (D) and
5/16" nylock nuts (G). Do not tighten yet. Repeat for
the L.H. hitch tube.
5/16" NYLOCK NUT (G)
5/16" x 1-1/2"
CARRIAGE BOLT (D)
5/16" x 2-1/2" hex bolts (A), 5/16" small flat washers (I)
and 5/16" nylock nuts (G). Do not tighten yet.
5/16" x 2-1/2"
HEX BOLT (A)
2
3
5/16" NYLOCK
NUT (G)
5/16" SMALL FLAT
WASHER (I)

Publicidad

loading