Publicidad
For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
ImPORTANT:
Do not over bend the support rods during
the following step. Over bending will cause the steel rods
to loose supporting tension.
10. (Figure 16) Tip the hopper onto it's back to assemble
the two hopper support rods. Place the ends of each
rod into the upper and lower rear hopper tubes, bending
the rod just enough to fit into the holes in the tubes.
SUPPORT
RODS
11. (Figure 17) Feel along the stitched flap on the hopper
bag to locate the hole in each upper hopper side tube.
Pierce a hole through both sides of the stitched flaps
in alignment with the lower hole.
UPPER HOPPER SIDE TUBE
ENGLISH
12. (Figure 18) Insert a 3/8" x 3" clevis pin (S) through
13. (Figure 18) Assemble a vinyl cap (V) onto the end of
16
14. (Figure 19) Secure the rope to the top center of the
17
9
www.mymowerparts.com
the lower hole in each upper hopper side tube. Next,
assemble a bag arm tube (pointing in direction shown)
onto each clevis pin and secure it with a 3/32" hair cotter
pin (O).
each bag arm tube.
LOWER HOLE
VINYL CAP
hopper bag frame.
18
3/32" HAIR
COTTER PIN (O)
3/8" x 3"
CLEVIS PIN (S)
BAG ARM TUBE
19
Publicidad
