Publicidad
For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
11. (Figure 8) Insert a 5/16" x 3/4" hex bolt (F) through the
angle bracket. Assemble onto the bolt (in order) the
spacer bushing (T), the height adjustment strap, a 5/16"
flat washer (J) and a 5/16" nylock nut (G). Tighten.
5/16" x 3/4"
HEX BOLT (F)
HEIGHT
ADJUSTMENT
STRAP
12. (Figure 9) Position the height adjustment handle side to
side so that the tooth lock washer (M) can fit between
the handle and the height adjustment strap. Tighten
the nuts securing the height adjustment handle.
13. (Figure 9) Insert the 5/16" x 1" carriage bolt (E) through
the height adjustment handle. Assemble onto the bolt,
in order, the 5/16" tooth-lock washer (M), the height
adjustment strap, a 5/16" flat washer (J) and the plastic
knob.
5/16" FLAT
WASHER (J)
PLASTIC
KNOB
TOOTH LOCK
WASHER (M)
ENGLISH
8
5/16" FLAT
WASHER (J)
SPACER
BUSHING (T)
5/16" NYLOCK
NUT (G)
9
5/16" x 1"
CARRIAGE BOLT (E)
www.mymowerparts.com
ASSEmBLY OF HOPPER BAG
1. (Figure 10) Turn a rear hopper tube so that the brace
holes in the middle of the tube face down.
REAR HOPPER TUBE
(brace holes on bottom)
2. (Figure 11) Insert the two upper hopper side tubes
through the stitched flaps on each side of the hopper
bag.
3. (Figure 11) Assemble the ends of the rear hopper tube
onto the ends of the upper hopper side tubes. Fasten
together using plastic plugs (Z).
7
PLASTIC PLUG (Z)
UPPER HOPPER
SIDE TUBE
10
11
Publicidad
