View The Data - Tecnotest EZ-SCAN 4000 Manual Operativo


EZ-SCAN 4000 ___________________________________________________________________________
3.1 -

View the data

•
Your vehicle must be scanned before viewing the data. If DATA is pressed, and
the vehicle has not been scanned, the scanner will display Press the Scan key to
Scan New Data.
The EZ-Scan 4000 scanner DOES NOT need to be connected to the vehicle to view the
scanner data. The vehicle engine configuration and data will remain in the scanner's
memory until a vehicle is scanned again. This allows you to review the data at a later
time, or to use PC-Link to load the data into a computer.
•
If the EZ-Scan 4000 scanner is not ON, press POWER to display the opening
screen.
•
Press DATA to display the Data menu. Make sure 1-Op Data is highlighted, then
press ENTER.
•
Information from the computer/sensors in your vehicle (Operational Data Items)
will be displayed on the scanner screen. A reference number is displayed in the
upper right corner of the screen (THE total number of sensors and sensor types
will vary with each type of vehicle).
NOTE:
The and or
•
To see a description of each of the Operational Data Items for your vehicle, refer
to the appropriate section on the following pages.
Operational Data Items
To see a description of each of the Operational Data Items for your vehicle, refer to the
appropriate section on the following pages:
•
"OBD-II Generic Operational Data Items" on chapter 5.0.
42
and arrow keys will step through the sensors a page at a time.
OPERATING INSTRUCTIONS