Mon - Obd-Ii; Capture Mode - Tecnotest EZ-SCAN 4000 Manual Operativo


EZ-SCAN 4000 ___________________________________________________________________________
4.0 -

MON - OBD-II

4.1 -

Capture mode

NOTE:
The maximum number of data items that can be viewed in Capture Mode is 20.
•
Use Capture Mode to help diagnose intermittent problems that occur while driving
the vehicle by capturing data before, during, and after a problem occurs.
•
[OBD-II] The Capture Mode will capture up to a maximum of 20 data items.
Use Customize Data function to select which data items to be captured and
displayed. See chapter 3.6 "Customizing Data Items - OBD-II".
•
[ALL] Your vehicle must be scanned before using Capture Mode. If ENTER is
pressed to select 1-Capture Mode, and the vehicle has not been scanned, the
scanner will display Press the Scan key to Scan New Data. Refer to "Scanning
the Vehicle" on chapter 3.0.
CAUTION:
It is recommends that the person operating the vehicle does not use/view
the scanner.
•
Always use an assistant to operate the scanner while driving the vehicle.
•
Make sure the EZ-Scan 4000 scanner cable is out of the driver's way, and is
correctly connected to the scanner and to the vehicle, then press POWER.
•
Press MON to display Monitor menu. [OBD-II] Make sure 1-Capture Mode is
highlighted, then press ENTER. Make sure 1-Start Capture is highlighted, then
press ENTER.
•
The screen will display Capture Mode and then up to seven '>' symbols.
Each '>' symbol represents a user defined length of time.
NOTE:
When Capture Mode is started, the scanner will begin displaying '>' symbols.
Each symbol represents two frames of data. The default setting for each frame is one
second. Refer to "Set the Time Units for Capture Mode" on chapter 2.5 to change the
setting.
46 OPERATING INSTRUCTIONS