Maintenance Maintenance And Inspection - Hitachi NT50AF Manual De Instrucciones Y Seguridad

MAINTENANCE
NOTE:
The information contained in this Manual is designed to
assist you in the safe maintenance of the Tool.
Some illustrations in this Manual may show details or at‑
tachments that differ from those on your own Tool.
MAINTENANCE AND INSPECTION
Read section titled "SAFETY" (page 4-9)
•
Disconnect air hose and remove all fasteners from Tool when:
1) doing maintenance and inspection; and
2) clearing a jam.
1. Resetting the Piston / Driver Blade
Disconnect from the Air source.
Unload all of the fasteners from the magazine.
Make sure there are no fasteners in the guide chamber.
Reconnect the air source to the Tool.
While squeezing the safety lever, push the ram down and hold
for three (3) seconds and release.
Load fasteners and proceed with the operation of the Tool.
2. Inspecting the Magazine
o
DISCONNECT THE AIR HOSE
o
Clean the magazine. Remove dust or wooden tips which may
have accumulated in the magazine.
3. Storing
o
When not in use for an extended period, apply a thin coat of the
lubricant to the steel parts to avoid rust.
o
Do not store the Tool in a cold weather environment. When not
in use, the Tool should be stored in a warm and dry place.
o
Keep out of reach of children.
WARNING
— 27 —
English