Adjusting The Carburettor (Honda / Robin); Operation At High Altitudes; Cleaning The Sediment Bowl (Honda / Robin) - ENAR TEN2540 Manual De Instrucciones

7.5 ADJUSTING THE SPEED OF THE MOTOR ( HONDA / ROBIN MOTOR)
The motor should run with full load at 3600±100 r.p.m.
7.5.1.
7.5.2.
7.5.3.
7.6 ADJUSTING THE CARBURETTOR ( HONDA / ROBIN MOTOR)
!
expose to flames without protection; do not smoke.
7.6.1.
7.6.2.

OPERATION AT HIGH ALTITUDES:

At high altitudes, the mixture of air and fuel in the normal carburettor
will be much too rich. The machine's performance will diminish and
its fuel consumption will rise.
Performance at higher altitudes can be improved by carrying out specific modifications on the
carburettor. If the motor always operates at altitudes of more than 1,500m above sea level, ask your
authorized Honda dealer to carry out these modifications on the carburettor.
Even in the case of an appropriate carburettor, the power of the engine will be reduced by
approximately 3.5% for every 300-metre increase in height. The effect of the altitude on the power of
the motor will be all the greater if the carburettor is not modified.
!
carburettor has been adjusted may lead to an inferior rate of performance, overheating, and serious
damage to the motor caused by the air and fuel mixture flowing too fast.
7.7 CLEANING THE SEDIMENT BOWL ( HONDA / ROBIN MOTOR)
7.7.1.
7.7.2.
7.7.3.
7.7.4.
REVERSIBLE PLATE COMPACTORS
TEN2540-TEN2550-TEN3040-TEN3050
Place the motor on top of a mattress
Start up the motor and let it warm up a few minutes
Place on full throttle by pushing the lever inwards to increase the speed and then release
to reduce the speed reached. Check that the accelerator reaches full throttle when
measuring the r.p.m.
ATTENTION: When working on the combustion system, do not
Start up the motor and wait until it has reached the
working temperature.
Leave the motor idling and turn the throttle until the
standard idling speed is reached: 1400
ATTENTION: Operation of the pump at an altitude that is lower than the one for which the
Shut off the fuel valve.
Remove the sediment bowl with the O-ring gasket.
Wash them in non-flammable solvent, dry out and put back firmly in position.
Open the fuel valve, check there are no leaks and that the area is dry before proceeding
to start up the motor.
+
200
r.p.m.
−
150
O-RING
GASKET
en
21