Air Filter - Hoshizaki RTE-120SNA Manual De Instrucciones

Fig. 9
* Do not use the following items. They could damage
painted or plastic surfaces:
Polishing powder, alcohol, thinner, benzine, acidic
or alkaline detergent, hot water, petroleum, soap
powder, metal scourer or brush, etc.
Especially detergent to clean grease on ventilator
or microwave.
Fig. 10
Note: Some solutions other than the above may
also damage painted or plastic surfaces.
Immediately stop using such solutions if
they cause any problems.
* The door gasket and its contact surface get
soiled easily. Clean every surface of these parts
thoroughly. Remnants of food will accelerate aging.
* Use a cloth to wipe off any water staying inside the
cabinet.

2. AIR FILTER

Plastic mesh air filters remove dirt or dust from the
air, and keep the condenser from getting clogged.
If the filters get clogged, the refrigerator/freezer's
performance will be reduced. Check the filters at
least twice a month. When clogged, use warm water
and a neutral cleaner to wash the filters. Do not
operate the unit with the air filters removed, or the
condenser will get clogged, resulting in failure.
1) Remove the air filter from the front panel.
2) Wash the air filter carefully with cold or warm
water containing the proper amount of neutral
cleaner. Rinse and dry the air filter thoroughly.
3) To refit the air filter, put the two tabs into the
bottom slots in the front panel, and tightly attach
the air filter over the entire slots by using the
magnet provided.
Slot
IV. BEFORE CALLING A SERVICE AGENT
IMPORTANT
1. If the temperature display window on the
operation panel indicates an error code
or something seems wrong with the unit,
check for possible causes according to the
following instructions. If the problem still
exists, immediately contact an authorized
Hoshizaki service company.
2. When contacting a service company, let
them know the model name, serial number,
date of installation (see warranty card) and
state of the trouble.
3. Do not attempt to repair the unit yourself.
1. TROUBLES WITH ERROR CODE
INDICATION
When the temperature display window on the
operation panel flashes alternately between an error
code and the cabinet temperature, check the error
code and follow the instructions below.
1) If one of the following error codes is displayed,
immediately contact an authorized Hoshizaki
service company.
Code
E3 Defrost time too long.
E8, E9 Thermistor defective.
EA, ED Controller board defective.
5
ENGLISH
Front Panel
Tab
Magnet
Air Filter
Fig. 11
Problem