melitta Caffeo Solo & Milk Manual De Instrucciones página 30

Transport, Storage and Disposal
Malfunction
Coffee only fl ows drop-
by-drop.
Coffee does not fl ow.
The grinder is not
grinding.
Loud grinder noise.
Bean symbols
fl ashing although the
bean container is full.
Appliance indicates
"no water" even though
the water tank is fi lled.
illuminates on the
display.
The symbol is
illuminated without a
reason.
The cleaning or
descaling process was
interrupted.
Not enough milk froth
is formed during the
frothing process.
The brewing unit can
no longer be reinserted
after removal.
30
Troubleshooting
Cause
Grinding fi neness is too fi ne.
Water tank not fi lled or
incorrectly inserted.
The brewing unit is clogged.
The beans are not falling into
the grinder.
Foreign objects in the grinder.
Foreign objects in the grinder.
are
Insuffi cient quantity of ground
beans in the brewing chamber. Press the
The fl oat is blocked.
There is air in the lines inside
the appliance.
The power supply was
interrupted, e.g. due to a
power outage.
The nozzle of the steam pipe
is in the wrong position.
The steam pipe nozzle is dirty. Clean the nozzle.
The brewing unit is not
properly locked.
The actuator is not in the
proper position.
Operating Instructions: Melitta
Measure
Adjust the grinding fi neness more
coarse.
Clean the brewing unit.
Perform a descaling or cleaning
programme if necessary.
Fill the water tank and make sure it is
properly inserted.
Clean the brewing unit.
Tap lightly on the bean container.
Call the hotline.
Call the hotline.
button or
Check the condition of the fl oat in the
water tank, remove the water and
carefully shake the tank.
Turn the valve switch 11 clockwise
until it stops until water fl ows out of the
appliance.
Clean the brewing unit if necessary.
The appliance performs a rinsing
program autonomously. To do
so, follow the instructions on the
appliance.
Adjust to the proper position.
Check whether the handle for locking
the brewing unit is correctly engaged.
Switch the appliance off and then on
again. Press the
buttons simultaneously for longer than
2 seconds. The actuator is put into
position. Then reinsert the brewing unit
and make sure it is correctly locked
into place.
Solo & Milk | 1829-0618 | 2018-08
® ®
button.
and