Publicidad
Idiomas disponibles
Idiomas disponibles
3.
Examine the leveling legs. Find the diamond marking.
4. Screw the legs into the leg holes by hand. Use a wrench to
finish turning the legs until the diamond marking is no longer
visible.
5.
Place a carton corner post under each of the 2 dryer back
corners. Stand the dryer up. Slide the dryer on the corner
posts until it is close to its final location. Leave enough room
to connect the exhaust vent.
6. Once connection
is made and dryer is in final location,
remove corner posts and cardboard.
For mobile home use
Gas dryers must be securely fastened to the floor.
Mobile home installations require a Mobile Home Installation Kit.
See "Tools and Parts" section for ordering information.
A combination
of pipe fittings must be used to connect the
dryer to the existing gas line. Shown following is a
recommended
connection. Your connection may be different,
according to the supply line type, size, and location.
!
3
1. _in.
flexible gas connector
2. _in.
dryer pipe
3. _/#in. to ._in. pipe elbow
4. _in. pipe-to-flare
adapter fitting
3. Open the shutoff valve in the supply line. The valve is open
when the handle is parallel to the gas pipe.
Check the levelness of the dryer. Check levelness first side to
side, then front to back.
41
1. Closed valve
2. Open valve
Test all connections
by brushing on an approved
noncorrosive leak-detection
solution. Bubbles will show
a leak. Correct any leak found.
If the dryer is not level, prop up the dryer using a wood block.
Use a wrench to adjust the legs up or down and check again for
levelness.
NOTE: It might be necessary to level the dryer again after it is
moved into its final position.
1. Using a 4 in. (10.2 cm) clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure the vent is
clean. The dryer vent must fit over the dryer exhaust outlet
and inside the exhaust hood. Make sure the vent is secured
to exhaust hood with a 4 in. (10.2 cm) clamp.
2.
Move dryer into final position. Do not crush or kink vent.
Make sure dryer is level.
3. (On gas models) Check to be sure there are no kinks in the
flexible gas line.
1o Remove the red cap from the gas pipe. Move the dryer close
to its final position.
2.
Using a wrench to tighten, connect the gas supply to the
dryer. Use pipe joint compound
on all non-flared male
threads. If flexible metal tubing is used, be sure there are no
kinks.
NOTE: For L.R gas connections,
you must use pipe joint
compound
resistant to the action of L.R gas. Do not use
TEFLON '_tape.
You can change your door swing from a right-side opening to a
left-side opening, if desired.
Reversible Large Side-Swing Door
/
8
Publicidad
