FAZUA evation i.o Manual Original página 14

EN
Operation
Requirements
For running the eBike drive system, following requirements must be met:
• The Battery Pack is sufficiently charged, inserted and turned on (see
Battery Pack Instructions).
• Drivepack is mounted in the eBike.
• The speed sensor is properly connected to the Bottom Bracket and
spoke magnet justly placed (see Bottom Bracket Instructions).
Switching eBike System On/Off
To switch on the eBike press any of the Remote buttons (2,3,4). The Remote (1)
will shortly show the start-up animation and get into operation mode.
To switch off the eBike from the Remote (1) you have to press and hold the
middle button (3) of the Remote (1) for 2 s.
Other alternative options to switch off the eBike are:
Unmounting the Drivepack from the bike (see Drivepack Instructions).
•
Switching off the Battery Pack (see the Battery Pack Instructions).
•
• Letting the eBike enter into inactivity (see Drivepack Instructions).
Note! Always switch off the eBike system when you park the eBike.
Display of the Remote
The display bar (5) on the Remote (1) consists of 11 LEDs.
The top LED is the notification indicator (7) meant for eBike status
•
notification.
• The remaining 10 LEDs are meant for the state-of-charge and support
level bar (6).
24
State-of-charge and support level bar
The state-of-charge and support level bar (6) shows 2 parameters:
• State-of-charge of your Battery Pack.
• Selected support level of your eBike.
The state-of-charge of your Battery Pack is indicated by the number of LEDs
that are lit. Each LED represents 10% of the total capacity. When charge at
the Battery Pack is full, all 10 LEDs are lit. However, if Battery Pack is empty,
then no LEDs will light up.
The selected support level is represented with the color of the bar (6). There
are 4 possible colors this bar (6) can show and they refer to the 4 different
support levels.
Notification indicator
The notification indicator (7) will show notifications of errors or events in the
eBike in case they occur. If no errors are detected, the notification indicator
should not light up.
Different colors on the notification indicator (7) have different meanings :
• Green: The notification indicator (7) briefly blinks green when the
Drivepack is mounted in the eBike. This provides visual feedback that
the system is ready to be switched on.
• Yellow: The notification indicator (7) lights up yellow if a "Soft Fault" is
detected. This means that temporary or minor flaws are present and,
probably, a limitation in performance. Riding your eBike under a "Soft
Fault" is possible but not recommended.
• Red: The notification indicator (7) lights up red if a "Hard Fault"
is detected. The eBike system will not work under a "Hard Fault"
condition and your eBike will need Service.
Note! The most common cause for a "Soft Fault" in your eBike is
the missing information from the Speed Sensor (see the Bottom
Bracket Assembly instructions).
In case of a permanent "Soft Fault", try reassembling the speed sensor magnet
(See Bottom Bracket Instructions). If this problem persists contact your FAZUA
Service Partner or visit the FAZUA Service Platform (www.fazua.com/service).
In case of a permanent "Hard Fault", contact your FAZUA Service Partner or
visit the FAZUA Service Platform (www.fazua.com/service).
EN
25