Wiring Diagram; Maintenance Instructions - Associated 6002B Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CHARGING SULFATED BATTERIES
If your battery has sat in the discharged state for an extended period of time, it can become SULFATED. This usually is seen as a white
deposit near the top of the battery. The sulfate is formed when a battery with low water levels remains discharged for an extended time.
Sulfated batteries exhibit the characteristic of accepting no charge regardless of the rate of charge.
The charging method is two staged. The first stage of attempting to break down the sulfation to allow the battery to accept a charge must be
closely watched to avoid excessive charge rates as the battery begins to charge and overheat. The second stage is a slow charging to restore
the battery to full charge.
READ AND FOLLOW ALL PRECAUTIONS AND WARNINGS IN YOUR INSTRUCTION MANUAL BEFORE ATTEMPTING TO CHARGE
SULFATED BATTERIES. FAILURE TO OBSERVE THESE WARNINGS MAY RESULT IN PROPERTY DAMAGE OR SERIOUS PERSONAL
INJURY OR DEATH.
To recharge a sulfated battery:
1.
Attach the battery clamps as described in the instruction manual.
2.
Always use the charger's lowest rate when turning the charger on. Set the charger to the charger's highest rate for the voltage of the
battery being charged.
CAUTION: NEVER CHARGE A BATTERY AT VOLTAGE RATES ABOVE THAT OF THE BATTERY.
3.
The battery will show little or no amperage at the start of the charging process. This will continue until the sulfation begins to break
down.
CAUTION: AS THE SULFATION BREAKS DOWN, THE AMPERAGE MAY RAPIDLY RISE. CONSTANT
ATTENTION MUST BE OBSERVED TO PREVENT SERIOUS OVERHEATING OF THE BATTERY.
4.
Lower the charge rate to the lowest rate for the voltage of battery being charged.
5.
Charge the battery at this low rate until the electrolyte reaches the fully charged state as described in the tables in your instruction
manual. This may take as long as two or three days.
NOTE:
SOME BATTERIES MAY BE SO BADLY SULFATED THEY CAN NOT BE RESTORED TO A NORMAL OPERATING CONDITION,
REGARDLESS OF THE RATE OF CHARGE OR THE LENGTH OF TIME THE CHARGE IS APPLIED. IF THE BATTERY CANNOT
BE RESTORED TO A FULLY CHARGED CONDITION BY A SLOW CHARGING, IT SHOULD BE REPLACED.
TIMER
6
5
4

MAINTENANCE INSTRUCTIONS

Worn clamps and jaws should be replaced. Worn parts can lead to poor connections and present a safety hazard. See parts list for part number of
jaw and clamp kits. Any Maintenance or repair of this unit that involves disassembly of the cabinet should be done only by a qualified serviceman.
Incorrect reassembly may result in a risk of electric shock when the unit is subsequently used.

WIRING DIAGRAM

YELLOW
YELLOW
VOLTS
1
AC
CHARGE
CIRCUIT
8
4
2
6
BREAKER
BLACK
WHITE
WHITE
1
AMPS
CHARGE
8 4 2
6
PROBE
BROWN
BLACK
GRAY
YELLOW
RESISTOR
L.BLUE
RED
PURPLE
WHITE
TRANSFORMER
"STOP LITE"
JAW GUIDE
5
AMMETER
+
DC
CIRCUIT
BREAKERS
RECTIFIER
NEG.
POS.
(BLACK)
(RED)

Publicidad

Tabla de contenido
loading

Tabla de contenido