[A]
Memory
Shows the active memory position. At start up the initial position is 00. To activate
a different memory, select this field (seen shadowed in figure 5) and activate it by
pressing the rotary selector. Then, by turning it, it will be possible to load one of
the stored memories (from position 00 to 31). This field appears in all the
configuration menus.
[B]
STORE
Allows storing the parameters active in the three configuration screens onto a
memory position. To do this, after selecting the STORE field (appearing
shadowed), press the rotary selector to activate it (appears underlined), turn to
select the memory number according to the STOXX format (XX from 00 to 31),
and finally press the rotary selector again until you hear the confirmation signal
(the current state of all the parameters of the three configuration menus will then
be stored in the chosen memory). This field appears in all the configuration
menus.
[C]
SIGNAL LEVEL
Signal level at the RF output in dBV, variable in jumps of 1 dB. Maximum
attenuation 60 dB.
[D]
FORMAT
Format selection between 4:3 or 16:9.
[J]
TELEVISION SYSTEM
Television system selection between B/G, I, D/K, L, M or N
[P]
COLOUR SYSTEM
Colour system selection between PAL, SECAM or NTSC.
[Q]
TUNING MODE
Tuning mode selection between tuning by frequency FRQ, or tuning by channel,
in the latter case the name of the channel table appears in the display: CCIR,
STD L, OIRT or FCC (on the basis of the stored channels, see appendix A).
[R]
TUNING
RF output frequency selection. In the frequency tuning mode this parameter can
vary between 37 MHz and 865 MHz in progressive jumps of 50 kHz. The name of
the channel appears if in the channel tuning mode.
PARAMETERS REGARDING SOUND MODULATION:
[E]
SOUND SYSTEM
Selection of sound system between MONO, ZWEITON, NICAM and Sound OFF
(without carrier).
[F]
2nd SOUND CARRIER
Selection of sound between STEREO and DUAL
[G]
LEFT SOUND CHANNEL MODULATION
Activation, Left ON, or deactivation, Left OFF, of the left sound channel.
Page 26
Colour pattern generator GV-798+
06/2016