Maintenance - SPARKY TSB 1300C Instrucciones De Uso

tion for thermal overload of the power tool. Upon
this event please contact the nearest SPARKY
service centre to diagnose your power tool.
To avoid thermal overload of the power tool we
recommend to switch off the machine after each
prolonged operation until it reaches ambient
temperature. A fair criterion for determination of
the thermal overload beginning is when you feel
the gear high temperature even with your hands
in gloves.
ACCESSORIES
Blades.

Maintenance

WARNING: Always ensure that the
tool is switched off and unplugged before
attempting to perform inspection or mainte-
nance.
BRUSH REPLACEMENT
This power tool is equipped with auto-stop
brushes. When the carbon brushes are worn
out, the machine switches itself off. In this case
both brushes must be replaced simultaneously
with genuine brushes at SPARKY service centre
for warranty and post-warranty service.
GENERAL INSPECTION
Regularly inspect all fasteners and ensure they
are properly tightened. Should any of the screws
be loose, retighten it immediately to avoid haz-
ards.
If the replacement of the supply cord is neces-
sary, this has to be done by the manufacturer or
his agent in order to avoid a safety hazard.
CLEANING
and its ventilation slots clean (3).
Regularly check to see if any dust or foreign
matter has entered the ventilation slots and the
grills around the switches. Use a soft brush and/
or air jet to remove any accumulated dust. Wear
safety glasses to protect your eyes whilst clean-
ing.
Exterior plastic parts may be cleaned with a
damp cloth and mild detergent if necessary.
Original instructions
WARNING:
agents to clean plastic parts.
WARNING: Water must never come
into contact with the tool.
IMPORTANT! To assure product safety and re-
liability, repairs, maintenance and adjustment
(including brush inspection and replacement)
using genuine replacement parts.
9
EN