Operating Instructions; Setting The Clock - Danby DMW902W Manual Del Propietário

POWER PAD
Oven automatically cooks at high power. For a
lower power level, set cook time, touch
POWER and enter number (1-9) for lower
power level.
TIMER PAD
Independent kitchen timer. Set any time even
while oven is operating. Touch TIMER pad, set
time then START. Touch RESET to cancel.
COOK PAD
Cook at one power level for a period of time,
then automatically switch to another power
level for the remaining cook time.
COOK BY WEIGHT
Touch COOK pad, enter weight of meat accu-
rately, then START. After partial cooking, oven
stops, leaving time on display. Turn over meat
when oven stops after partial cooking. Re-
touch START to finish.

1.SETTING THE CLOCK

A. Setting the clock when the oven is
plugged in.
• When the oven is first plugged into a wall
outlet, touch the CLOCK pad once, the
display will show "ENTER CLOCK TIME".
• Enter the correct time of day by touching
the correct number pads. You must set at
least 3 digits (one for hour(s) and two for
minutes). For minute less than 10, precede
the "minutes" digit by a 0. Example: for 5
minutes past 2, set 2:05. The colon will
flash between hour and minute digits. If you
prefer not to have the clock displayed, set
the clock for 00:00 and the display will only
show a colon.
• Touch START/STOP to lock in the time.
Colon will stop flashing and clock will begin
to keep current time. After clock has been
set, the word prompt clock will always show
on the display unless oven is in a
cooking operation.

OPERATING INSTRUCTIONS

7
DEFROST BY WEIGHT
Automatic defrosting for large meats. Controls
power level to thaw without excessive
outside warming.
SPEED DEFROST
Automatically programs lower power levels for
even defrosting. Touch SPEED DEFROST, set
time and START.
CLOCK
Touch pad once, touch number pads and
START to set clock.
RESET
Touch to clear display of unused time after
cooking, also cancel timer.
START/STOP PAD
Touch as final step in setting oven. Touch to
stop microwaving while oven is in operation
(re-touch to continue timing shown on dis-
play). Will not stop timer.
B. Changing the clock time.
• Touch the CLOCK pad once, the display will
show" ENTER CLOCK TIME"
• Enter the correct time of day by touching
the correct number pads. You must set at
least 3 digits (one for hour(s) and two for
minutes). For minute less than 10, precede
the "minutes" digit by a 0. Example: for 5
minutes past 2, set 2:05. The colon will
flash between hour and minute digits. If you
prefer to not have the clock displayed, set
the clock for 00:00 and the display will only
show a colon.
• Touch START/STOP to lock in the time.
Colon will stop flashing and clock will begin
to keep current time. After clock has been
set, the word prompt clock and time of day
will always show on the display unless oven
is in a cooking operation.