Fitting Instructions - medi protect.Ankle air Instrucciones De Uso

English
protect.Ankle air
Intended purpose
protect.Ankle air is an ankle joint brace. The product is exclusively to be
used for the orthotic fitting of the ankle joint and only on unbroken skin.
Indikationen
• Conservative and postoperative care of ligaments in the upper ankle
joint (second degree to III)
• After distortions
• In the case of chronic instability of the upper ankle joint
Contraindications
The orthosis is not to be used on open wounds

Fitting Instructions

• Open all the Velcro bands and Velcro fasteners.
• Adjust the width of the heel. Position the part that goes under the heel
using the Velcro fasteners so that the side parts fit well to the ankle.
• Put the ankle at a 90 degree angle. Put the orthosis on in such a way
that the heel is in the middle of the piece that goes under it and the side
parts are adjusted to the ankle.
• Close the bottom Velcro fastener first and make sure that the side parts
remain parallel.
• Close the top Velcro band.
• Pull one strap tight or pull on both straps alternately until the orthosis is
firmly in place and does not exert too much pressure on the ankle.
Using the included pump, you can regulate the air content of the blister
and thus individually adjust the comfort level for yourself. One nozzle of
the pump is used for inflation and the other for deflation.
Care instructions
Velcro fasteners should be closed for washing.
• Wash the product by hand, preferably using medi clean washing agent.
• Do not bleach.
• Leave to dry naturally.
• Do not iron.
• Do not dry clean.
    
Storage instructions
Keep the product in a cool, dry place and do not expose to direct sunlight.