Chapter 2: Functions; On/Stand By; 6Th Sense Fresh Control / Green Intelligence Profresh; Door Open Alarm - Whirlpool SW6 AM2Q W Instrucciones De Uso

2. FUNCTIONS

2.1. ON/STAND BY

This function turns On/Stand-by the refrigerator. To put
the product in Stand-by, press & hold the On/Stand-by
button for 3 seconds. All the icons turn off except
On/Stand-by icon back light to indicate that the
appliance is in Stand-by. When the appliance is in
Stand-by, the light inside the refrigerator compartment
does not work. Remember that this operation does not
disconnect the appliance from the power supply. To
switch the appliance On again, simply press the On/
Stand-By button .
2.2. 6TH SENSE FRESH CONTROL
PROFRESH
This function allows optimum storage conditions
(regarding temperature and humidity) to be quickly
reached inside the appliance. The fan must also be
switched on for it to work properly. The "6th Sense
Fresh Control" / "ProFresh" is activated by default To
activate or deactivate this function – see enclosed
Quick Start Guide.

2.3. DOOR OPEN ALARM

The Door Open Alarm is activated when the door is left
open for more than 5 minutes. Indication of the alarm is
shown by the blinking of the LED Door Light. If the door
is left open more than 8 minutes the LED Door Light
switches off.

2.4. FAST COOLING

The use of this function is recommended when
placing a very high quantity of food in the
refrigerator compartment.
Using Fast Cooling function it is possible to increase
the cooling capacity in the refrigerator compartment.
To maximize the cooling capacity, please keep the fan
switch on.

2.5. FAN

The Fan improves temperature distribution inside the
product, allowing better preservation of stored food.
By default, the fan is switched on. It is advisable to
keep the fan switched on, so that the 6th Sense Fresh
Control / Green Intelligence ProFresh function can work
properly and also when the ambient air temperature
is above 27 ÷ 28°C or if you notice drops of water
on the glass shelves or in sever humidity conditions.
Please note that when the fan is switched on it will
not continuously work. The fan will start/stop working
depending on the temperature and/or humidity level
inside the product. It is therefore absolutely normal if
the fan does not move even if the fan is switched on.
To activate or deactivate this function – see enclosed
Quick Start Guide.
Attention: Switching- off the Fan deactivate the 6th
Sense Fresh Control / Green Intelligence ProFresh
function.
Note:
Do not obstruct the air intake area with food items.
To guarantee the right performance at lower ambient
temperature (colder than 18°C) and to minimize Energy
Consumption, turn off the fan.
If the appliance has the Fan it can be equipped with the
antibacterial filter.
Remove it from the box placed in the crisper drawer
/
and insert into the cover of fan.
The replacement procedure is included in the filter box.

2.6. TEMPERATURE SETTING

The appliance is normally factory-set for operation at
the recommended medium temperature.
For details of setting temperature - see enclosed Quick
Start Guide.
Note: Displayed set points correspond to the average
temperature throughout the whole refrigerator

2.7. NO-FROST REFRIGERATOR COMPARTMENT

Refrigerator compartment defrosting is completely
automatic.
Droplets of water on the rear wall inside the refrigerator
compartment indicate that the automatic defrost phase
is in progress. The defrost water is automatically run
into a drain hole and collected in a container, where it
evaporates.

2.8. REFRIGERATOR LIGHT

The light system inside the fridge compartment uses
LEDs light, allowing a better lightning as well as very
low energy consumption.
If the LED light system does not work, please contact
the Service to replace it.

Important:

The refrigerator compartment light switches on when
the refrigerator door is opened. If the door is kept open
for more than 8 minutes the light will be automatically
switched off.
173