Troubleshooting - HSM Profi Pack P425 Instrucciones De Servicio

KHD Handels-GmbH - www.khd-kl.com - www.khd-handel.de - Fon +49 (0) 631 570 46 80 - Autorisierter HSM-Direkthändler

7 Troubleshooting

Fault Possible
cause
Cardboard
too thick
Continuous
lamp
Overloading ►Switching the machine off
Machine
does not start
Other faults
8 Cleaning
Switch off the machine and disconnect the power plug. When cleaning, only use a soft cloth
and a mild soap-water solution. However, no water must enter the equipment.
9 Disposal / recycling
Dispose of the machine in an environmentally sound way at the end of its service
life. Observe the current regulations when doing this. As legislation is subject to
ongoing changes, we request that you contact your local authorities at the ap-
propriate time. As the manufacturer, HSM would be pleased to advise you on the
disposal of your old machine.
02/2020
Remedy
►Press "Reverse" button.
The cutting unit runs
backwards.
Allow the Profi pack to cool for 20–30 minutes before
restarting.
If problem persists
►Contact HSM Service.
For our customer service addresses see page 192.
Profi pack P 425
in reverse and pushes the cardboard
english
15