Porter Cable C7501 Manual De Instrucciones página 5

WHAT CAN HAPPEN
• Your compressor is powered by
electricity. Like any other electrically
powered device, if it is not used
properly it may cause electric shock.
• Repairs attempted by unqualified
personnel can result in serious
injury or death by electrocution.
• Electrical Grounding: Failure to
provide adequate grounding to this
product could result in serious injury
or death from electrocution. Refer
to Grounding Instructions para-
graph in the Installation section.
WHAT CAN HAPPEN
• The compressed air stream can
cause soft tissue damage to
exposed skin and can propel dirt,
chips, loose particles, and small
objects at high speed, resulting in
property damage or personal injury.
WHAT CAN HAPPEN
• Touching exposed metal such
as the compressor head, engine
head, engine exhaust or outlet
tubes, can result in serious burns.
HAZARD
RISk OF ELECTRICAL SHOCk
• Never operate the compres-
• Never operate compressor with pro-
• Any electrical wiring or repairs
• Make certain that the electrical
HAZARD
RISk FROM FLYING OBjECTS
• Always wear certified safety equip-
• Never point any nozzle or sprayer
• Always turn the compres-
HAZARD
RISk OF HOT SURFACES
• Never touch any exposed metal
• Do not reach around protective
5 - ENG
HOW TO PREVENT IT
sor outdoors when it is rain-
ing or in wet conditions.
tective covers removed or damaged.
required on this product should be
performed by authorized service
center personnel in accordance with
national and local electrical codes.
circuit to which the compressor is
connected provides proper elec-
trical grounding, correct voltage
and adequate fuse protection.
HOW TO PREVENT IT
ment: ANSI Z87.1 eye protection
(CAN/CSA Z94.3) with side shields
when using the compressor.
toward any part of the body or
at other people or animals.
sor off and bleed pressure from
the air hose and air tank before
attempting maintenance, attach-
ing tools or accessories.
HOW TO PREVENT IT
parts on compressor during or
immediately after operation.
Compressor will remain hot for
several minutes after operation.
shrouds or attempt maintenance
until unit has been allowed to cool.