Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP
6
WORKSPACE
PLACEMENT
Leave 12 to 24 inches of clear space behind your eclips
Cutting Mat movement.
Place your eclips2 Machine at least 12 inches from the edge of your work surface
to prevent it from tipping over and causing possible injury.
ENVIRONMENT
Place eclips2 Machine on a clean, level, dry and sturdy surface.
STARTING THE MACHINE
DO NOT unplug USB cable from computer while Machine is in use.
NOTICE
This will cause loss of data.
Plug Power Cord into wall outlet. Plug
1
the other end into your eclips2 Machine.
CUTTING MATS
PLACING MATERIAL
ON THE CUTTING MAT
Peel back and remove plastic cover
1
from Cutting Mat.
LOADING THE CUTTING MAT INTO THE MACHINE
WARNING: MOVING PARTS Keep fingers, hair and clothing away.
Open cover (Cutting Mat can also
1
be loaded with Machine cover
closed.)
2 Machine to allow full
®
Press Power button (front of Machine shown).
2
Unplug Machine when not in use.
Only use fabric on Coral
color fabric Cutting Mat.
Align material to be cut with top-left
2
edge of Cutting Mat. Press evenly
into place.
Rollers
Rollers
Guides
Guides
Place Cutting Mat between Alignment
2
Guides and insert into Machine until the
leading edge touches the Rollers.
12" – 24"
Pressing Power button
again will turn the
Machine OFF.
12" - 24"
Front
Replace plastic cover
on Cutting Mat when
not in use.
When removing more intricate
3
shapes from Cutting Mat, an eclips
Die Pick or Scraper is recommended.
Activate loading using
eCAL software on your
Computer.
12"
Publicidad
