Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION:
After prolonged use, the Cutting Blade may not cut as precisely as it once did. To help prolong the life of the Cutting
Blade, remove it from the Blade Holder and clean it with Isopropyl Alcohol (rubbing alcohol) poured onto a clean
paper towel. Remove any material left inside the Cutting Blade Holder, using a Die Pick Tool.
Visit sizzix.com to see a complete selection of available accessories.
CAUTION: CUTTING HAZARD Blade is sharp, handle with care.
WARNING: CHOKING HAZARD Small parts. Keep away from children.
Printed on a ring around the Blade Holder Top are Blade Depth Settings, ranging from 1 to 6. These numbers can be
selected individually by turning the wheel to the number relative to the material you are using. Refer to page 4 for
more information about setting the Blade Depth.
CAUTION: CUTTING HAZARD Keep fingers away from exposed blade.
Lift open Machine Cover to
1
expose Carriage and Blade
Holder Clamp.
Non-Cutting Side
Always unplug Machine before removing or installing Blade Holder.
Guides
Clamp Screw
Loosen Blade Holder Clamp
2
by turning Clamp Screw
counterclockwise. Remove
Blade Holder.
Carefully insert new Blade into
4
hole at bottom of Blade Holder;
Blade is held in place magnetically.
Replace Blade Holder in Machine,
as shown on page 5.
CUTTING BLADE MAINTENANCE
CLEANING THE CUTTING BLADE
ADJUSTING THE CUTTING BLADE DEPTH
REPLACING THE CUTTING BLADE
Rollers
Push down on Blade Ejection Pin
3
to reveal Blade. Carefully remove
and discard used Blade.
MAINTENANCE
MAINTENANCE
Blade Ejection Pin
Blade
7
Publicidad
