Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
11. Replacement of spool
First, switch off and unplug the device. Wait until the
nylon thread has come to a halt. Then push the two
locking devices 1 at the sides of the cutting head, and
remove the cutting head cover 2 (fig. 9). Remove the
used thread coil and put in the new coil 3 such, that one
end of the thread 5 comes out of each outlet at the sides
of the cutting head (fig. 10). Please take care that the
spring 4 is properly seated under the thread coil. Finally,
close the cover by pushing it in its seat. Both locks must
properly engage.
12. Trouble shooting
•
Trimmer does not work: Check power supply (e.g.
by testing on another socket or by means of a volt-
age tester). Should it still not work, although the
socket is o.k., send it undismantled to an authorised
service station for repair.
•
Cutting line disappears into spool: Remove spool,
pull end of line through the metal outlet and reinsert
spool. In case nylon line is used up insert a new
spool with line.
Do not make any other repairs on your own; have
your trimmer checked and repaired by an authorised
dealer.
13. Storing
•
Clean the unit thoroughly, especially the cooling air
slots on the motor housing.
•
Do not use water to clean the device.
•
Store trimmer indoors in a dry, high or locked place
and keep out of reach of children.
14. Repair service
Repairs to electric power tools should only be carried out
by specialist electrical personnnel.
15. Waste disposal and environmental
protection
Dispose of the machine properly after it is worn out. Dis-
connect the mains cable in order to prevent misuse. Do
not dispose of the machine with the household waste. In
the interest of environmental protection, take it to a col-
lection point for electric machines. Your responsible local
authority can provide you with addresses and operating
times. Also take the packaging materials and worn out
accessories to the appropriate collection points.
Only for EU countries
Do not discard electric tools in the house-
hold waste!
In accordance with European Directive 2012/19/EC on
waste electrical and electronic equipment and its im-
plementation in national law, waste electric tools must
be collected separately for environmentally-compatible
re-use.
GB | Operating Instructions
Recycling alternative to the return invitation:
Instead of returning the electric equipment, the owner is
alternatively obligated to take part in the proper recycling
in the case of relinquishment of ownership. The waste
equipment can also be taken to a collection facility which
disposes of it in the sense of the national recycling man-
agement and waste acts. This does not pertain to the
accessory parts and auxiliary equipment without electri-
cal components accompanying the waste equipment.
16. Spare parts
The following information should be provided when
ordering spare parts:
•
•
GB-6
Type of machine
Item number of the machine
Publicidad
Capítulos
Tabla de contenido
