Filter Menu - Pentair IntelliFlo WhisperFlo VF Guide D’iNstallation

26
Priming Menu (Continued)
c) To set the System Priming Time:
scroll to the "System Priming Time" setting. Press the Select button to select
it. To enter additional priming time to ensure that the entire system is fully
primed, see step 4.
Any additional time required for the pool piping system to reach prime
after the pump is primed is called "System Priming Time." The "System
Priming Time" value is entered in minutes, from 0 to 5 minutes. (Default
0 minutes). Remember that the average system should prime quickly, and
that IntelliFlo has the ability to monitor itself to ensure that it is primed.
"System Priming Time" is for high volume, or complex systems that may
need additional priming time to relieve all the air from the pipes. The builder can program
a pre-determined amount of time, up to 5 minutes, to aid in relieving the air from difficult
filters or complex vertical plumbing. The "System Priming Time" should only be used
where large air traps become problems within the system. During the priming cycle at
each startup, the display will inform the user when System Priming is engaged and when
it is finished .
4. To change the setting, press the Left and Right arrows to select which digit to modify, then use the
Up and Down arrows to change the selected digit.
5. When you are done, press the Enter button to save the changes. To cancel any changes, press the
Escape button to exit edit mode without saving.

Filter Menu

IntelliFlo will calculate the required flow rate based on pool size, pool turns per day, cycles per day, and
schedule to control the pump motor speed and keep a constant flow. The filter mode can run schedules,
cycles, power saves, or features. The IntelliFlo internal scheduler will keep track of which function to
run. IntelliFlo is constantly monitoring the filter, when it detects that the system is dirty, it will display an
"Alert - Service System Soon" message on the control panel display. The user must then clean the filter by
performing a Backwash cycle
more information on backwashing).
To access the Filter menu:
1. Ensure that the green power LED is on and the pump is stopped.
2. Press the Menu button. "Pool Data" is displayed.
3. Use the Up and Down arrow buttons to find the"Filter" menu item. Press the Select button to
select it.
a) To set the Clean Filter Pressure:
"Clean Filter Pressure" setting. Press the Select button to select it. To change the
setting, see step 4 below.
This parameter can be set from 0,1 to 3,5 bar. (Default 1,0 bar). The typical setting
for most pools and filters is between 0,6 bar and 0,7 bar.
IntelliFlo VF Installation and User's Guide
Use the Up and Down arrow buttons to
(See "Backwash Mode" on page 17 and "Backwash Menu on page 45 for
Use the Up and Down arrow buttons to find the
®
Priming 12:15
0. MIN
System Priming Time
®
MENU 12:15
Filter