Panel Installation - mundoclima MUCR 12 HF Manual De Instalación

Air Conditioner DC Duct Type

7. PANEL INSTALLATION

1. Unload inner frame.
Slide the knob, release the buckle fromthe outside
frame hole, then unload the inner frame.
2. Hang the outside frame on the main body with
face down. (4 places at 4 corners).
Hang the belt on the hook of the main body.
NOTE
The signal wire of the remote control receiver must
be drawn out through the canvas air passage.
3. Fix the outside frame and the canvas air
passage with screws. Screw must be fixed on from
the bottom to the top.
4. Hang up the outside frame until it sticks to the
ceiling tightly.
5. Fix the main body and the outside frame with
the fix board of waist-shape hole (in two places)
• Hang one side of the fix board of the waist-
shaped hole on the hook of the main body.
• Tighten the other side of the board with screw to
the outside frame.
• Cut off the surplus part of the board with pliers.
• Bend the top of the broken end.
NOTE
When hanging up the outside frame with the fix
board of waist-shaped hole and the belt, stick the
outside frame tightly to the ceiling and fix it.
6. Install the inner frame on the outside frame (the
inverse sequence of unloading the inner frame).
NOTE
Connect the remote control receiver with the
indoor unit signal wires and fix it.
7. Install remote controller.
6
EN