mundoclima MUCR 12 HF Manual De Instalación página 30

Air Conditioner DC Duct Type
The Specification of Power
Type
Power
Circuit breaker / Fuse (A)
Indoor unit power wiring(mm )
Indoor/Outdoor
connecting wiring
2
(mm )
CAUTION
The reserved function is indicated in broken line table,users can select it when necessary
CAUTION
The reserved function is indicated in broken line
table,users can select it when necessary
Terminal Board Diagram
Please refer to the indoor unit wiring diagramfor
the wiring.
NOTE
The air-conditioners can connect with Central
Control Monitor (CCM). Before operation,
please wiring correctly and set system address
and network address of indoor units.
Phase
Frequency and volt
2
Outdoor unit power
Weak electric signal
18000 Btu/h 24000 Btu/h
1-Phase
220-240V - 50 Hz 220-240V - 50 Hz
30/25
3 x 1,0
3 x 2,5
3 core shield wire 3 core shield wire
CONTROL
As per the different usages to set the moving
switch on the PCB in the electric control box of
indoor unit.
After the setting , be sure to cut down the main
power supply switch, then turn it on again
Setting would be invalid without disconnecting the
power.
Please number the indoor units during the
installation. For example, for the first outdoor unit
,the number of the first indoor unit is 1-1, the
second indoor unit is 1-2, and the set address is
1 and 2 respectively, the others is analogical.
Model 1 show the address
'0-F' respectively,
that is, '0-15' indoor unit
12
36000-60000 Btu/h
1-Phase 3-Phase
380-415V - 50 Hz
40/25 40/25
3 x 1.0 3 x 1,0
3 x 2,5 5 x 2,5
3 core shield wire
Model 2 show the address
'0-F' respectively,
that is, '16-31' indoor unit
EN