Grinding Process Discman 4 - mbas Discman 4 Manual De Instrucciones

4.13 Grinding process Discman 4

We recommend testing the Discman on disused skis or snowboards.
Above all, after fitting the base edge tuning attachment, you should test the Discman on disused skis or
snowboards.
Ensure that the ventilation grilles are not covered during grinding!
before start of radius
Please read these operating instructions, and in particular
before using the Discman!
Before grinding, check the sliding blocks for wear and tight seating; replace if needed!
If the grinding disc is applied too heavily there is a risk of excessive heat development!
Always grind side edges before waxing to avoid wax clogging the grinding disc!
Before grinding use a side plane to remove protruding materials from the side edges!
36
36
Grinding direction
Lift off
Lower
before start of radius
chapt. 2.1 Safety information, page 25 carefully
Discman 2