Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING TV, CABLE TV, VCR
AND CD PLAYER
You can control basic functions of a TV, CABLE TV, VCR and CD
player with this remote control.
TO
ENTER
THE
ID
CODE
OF
THE
EXTERNAL
EQUIPMENT
Indicator
MODE SELECT
DIGIT buttons
(o-9)
SET
UP
Before attempting
to control them, be sure to enter the ID code
of the external equipment
to the remote control as follows,
1
2
3
4
Confirm
the
code
number
of the
external
equipment.
See the ID code list in the "APPENDIX
at the end of this
manual.
Press either the TV, CABLE, VCR or CD button
in
the MODE SELECT
area.
Press and hold the SET UP button for about 2.5
seconds.
Confirm that the indicator blinks twice while pressing the SET
UP button,
Press three DIGIT buttons
which correspond
to
the ID code of the external
equipment.
For example, if your CD player is an AIWA unit, the required
ID code is 124 or 157. In this case, press the DIGIT buttons in
the order of"1;
"2" and "4" (or "1; '(5" and "7" ).
After the third DIGIT button is pressed, the indicator
blinks
twice indicating
that the ID code is correct and is stored on
the remote control.
You can check the stored ID code by counting the indicator blinking,
1
Press either the TV, CABLE, VCR or CD button.
For example, to clheck the stored code for CD player, press
CD.
2 Press and hold the SETUP
button
for about 2.5 seconds.
3 Press "9: "9" and "O."
4 Press"1
;' and ccmnt the indicator
blinks.
For example, in the case that the stored ID is"1 57."
The indicator blinks once,
5
6
Press "2;' and ccwnt the indicator
blinks.
~it.~~..~
'..
~;$$$j;
The indicator blinks five times,
Press "3;' and count the indicator
blinks.
The indicator blinks seven times,
TO CONTROL TV, CABLE TV, VCR AND CD
PLAYER
1
2
CHANNEL -
VOLUME
DIGIT buttons
(O-9) and ENTER
MODE SELECT
VCRICD
lI:Pause, =: Stop,
POWER
t4<:Rewind,
E: Play,
FM :Fast forward
Ifl
Press any button in the MODE SELECT area (TV,
CABLE, VCR or CD).
The remote conlrol
is ready to operate the selected
mode
equipment.
Press one of the buttons
indicated
above.
For the use of the O – 9 and the ENTER
buttons,
see the
instruction
manual supplied with the unit to be controlled.
Other buttons indicated
above have the same function
which
you will find on the unit to be controlled.
m
Reenter the ID CCIDE of the external equipment after replacing
the batteries of the remote control.
s If there are plural
ID codes for external
equipment
in Ihe
"APPENDIX,"
try f?ach number listed until you can control the
external equipment.
ENGLISH
20
Publicidad
Capítulos
Tabla de contenido
