Wiring - Invacare Sonata Manual Del Usuario

Mattress support with mountable legs
On the mattress support with the mountable legs, the legs are
mounted with screws to the mattress support.
1.
Place the bracket on the cross tube.
2.
Insert the screws and tighten the bolts.
1574228-D
Height adjustable legs
The legs can be adjusted in 3 different heights with a pipe pin. Ensure
the pipe pin is fully inserted through both holes and that the pipe
pin is completely locked. Make sure that all four legs are adjusted
to the same height.
WARNING!
– The Diana side rail can not be used on the bed when
the bed is configured with adjustable legs without
castors and when the legs are mounted in the lowest
height.

3.6 Wiring

IMPORTANT!
Not correctly drawn wires can be damaged when
operating the sections with the motors.
– All wires must be kept clear of the floor and must not
block the castors.
– All wires (motors, hand control and mains) must be
connected to the control box
– The locking cam must be attached over the plugs in
the control box.
Connect the mains wire plug to the 230 V socket.
Setup
9