POS. DESCRIPTION
1A
Tank 25l
1B
Tank 40l
1C
Tank 25ll with heat exchanger
1D
Tank 40ll with heat exchanger
2
Red plastic washer
3
White plastic washer
4
Blue plastic washer
5
Relief/non return valve
6
Hose clamp
7
Discharge pipe
8 A
Element gasket
from S/N 100.000
8 B
Element gasket
from S/N 200.000
9A
Electric element
1200W 220V
9B
Electric element
500W 220V
9C
Electric element
1200W 110V
9D
Electric element
600W 110V
10
Bi-Thermostat
11
Power supply cable
12A
Boiler resistor cover 220V
12B
Boiler resistor cover 110V
13
Nut
14
Ground cable terminal
15
Washer
16
Screw 2,9 x 19
BOILER BXS25-40 - REV004A
CODE
SAMLB2532000
SAMLB4036000
SAMLB25320S0
SAMLB40360S0
• shut down power supply.
PECRBLRS0000
PECRBLBNC000
• Remove the protection cover (12) in order to reach
PECRBLBL0000
the thermostat (10).
MNVALS12S68P
• Push the reset button on the double thermostat (fig. 4).
PBF25100W000
• Replace on the protection cover (12).
PVTBGM10NT00
• Switch on power supply.
PGGRES000000
PGRM43500000
EVR12220N000
EVR05220N000
F
EVR12110N000
EVR06110N000
EVT15S000000
ECC30150G000
The overpressure release device must be activated regu-
PECRB2200000
larly to remove calcium deposits and to ensure that it is
PECRB1100000
not blocked.
MBD04MXEN000
ESCL04000000
Periodically check the joints of the water pipe instal-
MBR04X000000
lation; check the tightness of the securing screws and
MBV02919AXCC
replace them in case they are worn or corroded.
Also periodically check the electrical system working
order.
MAINTENANCE
WARNING: Quick
®
nautic water heaters are pro-
vided with a double thermostat with manual
reset that shuts down power supply in case of an
excessive water temperature.
If it happens, follow the instructions below:
WARNING: if the high temperature safety sys-
tem switches on repeatedly, call Quick
center.
MAINTENANCE
During wintertime, when the water heater is not
in use it should be drained using the lever of the
valve (5). This is to avoid serious damage caused
by freezing.
GB
®
service
15