Hydraulic Pump; Operating Sequence - Beta 3050/K Manual De Uso

OPERATION MANUAL AND INSTRUCTIONS
ELECTROHYDRAULIC CONTROL UNIT: Parts
Item
H OIL PLUG
G DOWN COIL
F UPPER PIN
E ELECTRIC MOTOR
D HYDRAULIC DISTRIBUTOR
C MASTER SWITCH
B POWER SUPPLY CABLE
A CONTROL PUSH BUTTON PANEL
HYDRAULIC PUMP: Specifications
TECHNICAL DATA
MAX. PRESSURE VALVE, CALIBRATED
TYPE
N.B.: Use ONLY hydraulic mineral oil in accordance with ISO/DIN 6743/4, the degree of contamination not exceeding class 18/14
in accordance with ISO3448 (DIN51519). Viscosity ISO VG 46.
OPERATION
- The controls of the jack are located on the portable push-button fixed to the jack by means of the power cable. The push-button
panel, which is supplied with the jack, accommodates the up and down control buttons.

OPERATING SEQUENCE

- Before getting on/off the jack with the motorcycle, make sure that the platform is at the minimum possible height from the ground
level.
- Get onto the platform with both wheels of the motorcycle at a walking pace.
- Switch off the engine and raise the motorcycle on its fork stand and/or fix it with the front wheel vice (optional).
- Get off the motorcycle and the jack.
- Fix the motorcycle to the platform by means of the straps (optional).
- To BRING UP the jack, press the UP BUTTON. Releasing the finger will cause the jack to stop in position. "Dead man's button".
- To BRING DOWN the jack, lift the mechanical safety catch by means of the hand-operated lever. Then press the DOWN
BUTTON. Releasing the finger will cause the jack to stop in position. "Dead man's button".
22
A
Figura N.3-4
B B
.
B
c c
C
Figures 3-4
Description
220 bar
geared
F
F
D
D
E
E
.
G
H
EN