Declaration Of Conformity - Beta 3050/K Manual De Uso

ISTRUZIONI PER L'USO
OPERATION MANUAL AND INSTRUCTIONS
PROBLEM
No operation.
Jack can go up, but it cannot go down.
Jack goes down very slowly.
Motor operates normally, but jack cannot be lifted.
Motor operates normally, but lift goes up very slowly.
Stated capacity cannot be lifted.
Lift cannot go down.
(EMERGENCY DESCENT).
Figures 10-11
A
B
12. SCRAPPING INFORMATION
- If the jack is no longer to be used, it should be made unserviceable by removing the power connection plug.
- If the jack is to be scrapped, it should be considered as special waste and thus disposed of in accordance with current
national laws.
13. PERIODIC TESTS AND REGISTER
A General Visual Inspection should be performed on a DAILY basis to check the following:
• The general state of the jack and whether any parts are damaged or missing;
• The legibility of the tags attached to the jack, in order to replace any illegible tags;
• Leaks in the hydraulic circuit. A slight dampening effect is admitted, provided that no drops form.
We hereby declare, assuming full responsibility, that the described product complies with all the relevant
provisions of Machine Directive 2006/42/EC and amendments thereto.
The Technical Brochure is available at:
BETA UTENSILI S.P.A.
Via A. Volta 18
20845 Sovico (MB)
ITALY
.

DECLARATION OF CONFORMITY

Electric system failure.
Descent solenoid valve failure.
Electric system failure.
Descent control valve does not operate normally.
Descent solenoid valve stopped in opening position.
Oil may be missing.
Descent solenoid valve partially open.
Suction filter partially clogged.
Pump damaged.
Maximum pressure valve not calibrated correctly.
Pump damaged.
Descent valve does not open (N.10-11). Power failure.
Call customer service.
Electrical fault.
C
Item
C KNURLED BRASS PIN TO BE
UNSCREWED ANTICLOCKWISE.
B KNURLED NUT OF SOLENOID VALVE
A DESCENT SOLENOID VALVE
CAUSE
Description

EN I
27