Publicidad
16
MX-V
English
To replace the left chinstrap cover (D-ring side), ensure the female chinstrap end
snap side of the chinstrap and the leatherette side of the chinstrap cover both
face outward, slip the chinstrap cover onto the chinstrap.
Position the plastic chinstrap anchor cover over the steel anchor and push the
cover in the anchor until the tab on the back of the cover snaps fully home.
To replace the right chinstrap cover (long side), ensure the cap side of the
chinstrap end snap (Arai logo impressed) on the chinstrap and the leatherette
side of the chinstrap cover both face outward, slip the chinstrap cover onto the
chinstrap.
Position the plastic chinstrap anchor cover over the steel anchor and push the
cover in the anchor until the tab on the back of the cover snaps fully home.
tO ReMOVe/RePlaCe neCKROll
First remove the cheekpads as per previous instructions. Next, undo two rear
bosses of the comfort lining as per previous instructions.
To remove the neckroll, grasps center of the neckroll firmly, rotate it to either
direction by 3cm - 4cm (1-1/4" – 1 – 1/2") and remove it from the helmet.
To wash the neckroll, put them into lukewarm water with small amount of
laundry soap or your own shampoo and wash gently by hand. Rinse well with
fresh water and wipe off with a soft cloth. Dry them in the shade at ambient
temperature. Do not machine wash or dry.
WaRnInG:
Never use petrol, thinner, benzene or any other solvents. Even mild and seemingly
harmless chemicals can cause damage over a short period of time.
To replace the neckroll, center and insert the neckroll frame into the slot between
the shell and EPS liner of the helmet. Locate the two tabs on the frame and press
both down until both are locked in the slot of the helmet. Place two rear bosses
of the comfort lining through the two rings of the neckroll and over the plastic
receptacles in the EPS liner and push them home until fully seated.
Publicidad
Capítulos
