Safety Devices; Use According To Intended Purpose; Residual Risks - Mafell NFU 50 Manual De Instrucciones Original

1 KKS-guiding device
1 milling head
1 lateral stop 625
1 position indicator
1 parallel stop cpl.
2 operating tools
1 operating manual
1 folder "Safety instructions"

2.6 Safety devices

Danger
These devices are required for the
machine's safe operation and may
not be removed or rendered
inoperative. If one of the safety
devices is defective, return the
machine to the MAFELL customer
service for repair. Never repair the
safety devices yourself.
The machine is equipped with the following safety
devices:
- Upper stationary saw guard
- Lower retractable saw guard
- Large base plate
- Handles
- Index mechanism and brake
- Hose connector
- Orange flashing warning light when tool is rotating
- Lateral access protection

2.7 Use according to intended purpose

The MAFELL cross-cut milling system NFU50 is
intended exclusively for processing wood and wood
panel materials such as three-layer panels, Multiplex,
Kerto (laminated veneer lumber) as well as insulating
panels, Styrodur and polyurethane rigid foam.
Intended use is the making of grooves, flattenings
and notches in materials. A secure support on the
workpiece is required for all work. The machine can
be used with or without guiding devices. Please
observe the respective instructions in this operating
manual when working with the different guiding
devices. They form an integral part of the intended
use. (see chapter 5.3 and 5.10)
The tool supplied was manufactured in accordance
with the European standard EN 847-1.
The use of third-party tools is not permitted. Please
make exclusive use of the tools recommended by
MAFELL.
Any other use than described above is not
permissible. The manufacturer cannot be held liable
for any damage arising from such other use.
So as to use the machine as intended, comply with
the operating, maintenance and repair instructions
specified by Mafell.
2.7.1 Plunge milling
Danger
Danger of recoil during plunge
milling! Plunging and reverse
milling is not permitted!

2.8 Residual risks

Danger
Even if used in accordance with its
intended purpose and despite
conforming with the safety
instructions, residual risks caused
by the intended use that can lead
to health consequences will always
remain.
- Touching the milling head in the area of the start-
up opening.
- Touching the part of the milling head that protrudes
below the workpiece when milling.
- Touching the milling head below the guiding device
before it enters and after it exits the workpiece.
- Touching the milling head below the guiding device
when it is lifted out when the machine has not
been retracted to the safe position.
-24-