Tabla De Contenido; Owner's Information - Xylem CentriPro AQUAVAR SOLO2 Manual De Instalación

Owner's Information

Owner's Information
Controller Model Number:
Controller Serial Number:
Pump Model Number:
Pump Serial Number:
Motor Model Number:
Motor SFA:
Tank Serial Number:
Installer:
Installer Telephone Number:
Installation Date:
Wire Lengths (Feet)
Service Entrance to Controller:
Controller to Well:
Top of Well to Motor:
Incoming Voltage:
NOTICE: RECORD THE MODEL NUMBERS
AND SERIAL NUMBERS FROM THE
PUMP AND CONTROLLER IN THIS
INSTRUCTION MANUAL FOR FUTURE
REFERENCE. GIVE IT TO THE OWNER
OR AFFIX IT TO THE CONTROLLER
WHEN FINISHED WITH THE
INSTALLATION.
Water Ends and CentriPro Motors include these extra data labels. Please attach them to the inside cover of the
Aquavar SOLO Controller for future pump and motor identification.
2
Submersible Pump
33GS15
PLEASE USE THIS CONTROLLER INSTALLATION, OPERATION AND TROUBLESHOOTING
MANUAL (IOM) IN CONJUNCTION WITH THE PUMP IOM. THE CONTROLLER IOM COVERS THE
CONTROLLER ELECTRICAL INSTALLATION AND ANY SPECIAL INSTALLATION PROCEDURES
REQUIRED WITH VARIABLE SPEED CONTROLLERS.
XYLEM WILL NOT BE RESPONSIBLE FOR ANY DAMAGES TO AN INSTALLATION WHERE THE
PRESSURE RELIEF VALVE IS ALLOWED TO DISCHARGE INTO A FINISHED LIVING SPACE OR TO
OTHERWISE DAMAGE A CUSTOMERS PROPERTY. PLUMBING SAFETY DEVICES SUCH AS PRESSURE
RELIEF VALVES TO AN APPROPRIATE DRAIN IS THE RESPONSIBILITY OF THE INSTALLER AND IS
OUT OF OUR CONTROL.
2
Table of Contents
Table of Contents
SUBJECT
1. Safety Instructions ..................................................... 3
Ratings ...................................................................... 3
Required Materials .................................................... 3
2. Typical Installation .................................................... 3
Controller ............................................................... 3-4
Pump and Piping ........................................................ 4
Splicing Drop Cable to Motor Leads .......................... 4
Tank Sizing and Tank Pressure Setting ........................ 4
Wiring - Transducer, Motor, etc. ............................ 4-6
Wire Sizing ................................................................ 6
User Interface Board .................................................. 7
3. Installer Pre-Start Selections ...................................... 8
Display and Button Functionality ............................... 8
Maximum Frequency (Speed) Switch ......................... 9
Dry Well Sensitivity ................................................... 9
Low Pressure Cut-Off ................................................ 9
Pressure Drop ............................................................ 9
Motor Overload Setting Dial ..................................... 9
4. Start Up Procedure .................................................... 9
Purging System, Adjusting Pressure ............................ 9
Pressure Adjustment ................................................... 9
Check for Leaks, Checking Rotation ........................ 10
5. Run/Stop Input Options .......................................... 10
6. Advanced Menu ...................................................... 11
7. Troubleshooting, Fault Codes .................................. 14
8. Insulation and Winding Resistance Tests .................. 19
Limited Warranty ........................................................ 20
CentriPro
Motor: M30432/300C313
3.00 HP
FLA: 9.2 SFA: 10.1
SF: 1.15 Hz: 60
Volts: 230 PH: 3
PAGE
®
LRA: 59